Gigabyte GA-Z77X-UP4 TH User Manual page 26

F_AUDIO(H)
7) mSATA (Solid-State Drive Connector, Controlled by the Intel Z77 Chipset)
The mSATA connector conforms to SATA 3Gb/s standard and can connect to a single solid-state drive. When
the mSATA connector is installed with a solid-state drive, the SATA2_5 connector will become unavailable.
DB_PORT
Voltage measurement module(X58A-OC)
PCIe power connector (SATA)(X58A-OC)
8) CLR_CMOS (Clear CMOS Jumper)
Use this jumper to clear the CMOS values (e.g. date information and BIOS configurations) and reset the
CMOS values to factory defaults. To clear the CMOS values, use a metal object like a screwdriver to touch
BIOS Switcher (SW4)
nts(G1.Sniper 3)
the two pins for a few seconds.
Hardware Installation
BIOS Switcher (X58A-OC)
1
1
PWM Switch (X58A-OC)
3 2 1
DIP
DIP
1 2 3
• Always turn off your computer and unplug the power cord from the power outlet before clearing
the CMOS values.
• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or
manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).
F_PANEL(NH)
mSATA
M_SATA
Open: Normal
Short: Clear CMOS Values
- 26 -
F_PANEL
(H61M-D2)
ACPI_CPT
(GA-IVB)
SMB_CPT
(GA-IVB)
CLR_CMOS
CI
DIS_ME
GP15_CPT
(GA-IVB)
XDP_CPU
XDP_PCH
(GA-IVB)