Table of Contents
Advertisement
E13
TROUBLESHOOTING
The following problems do not always indicate a hardware failure. Therefore, please use the
troubleshooting guide below before calling for repair service.
If, after following the guide none of the remedies work, unplug the TV set and call for service.
Quick
Service
Check List
Possible Causes/Remedies
Try a new channel to check for possible station
trouble.
TV not plugged in.
Outlet power OFF.
POWER switch of TV not ON.
Antenna not connected to terminal at the back
of the TV set.
If outside antenna is used, check for broken
wires.
Check for local interference.
Turn OFF using the
POWER switch,
then turn ON again after a minute.
Adjust COLOUR control.
Check batteries in the remote control.
Try fine tuning to correct.
Contrast setting in picture mode might be all
the way to the minus side. Press the
NORMAL button on the remote control to
correct.
Increase the volume.
This unit is equipped with a microprocessor. Its performance could be adversely affected by external
electrical noise or interference. If this should happen, unplug the unit and plug it in again after a few
minutes.
E14
SPECIFICATIONS
MODEL
21K-FD1SA
Receiving System
World multi 21 system
TV Broadcasts/
PAL-I
VCR Playback
PAL-B/G
PAL-D/K
VCR Playback
NTSC 4.43/5.5 MHz/60 Hz
NTSC 4.43/6.0 MHz/60 Hz
NTSC 4.43/6.5 MHz/60 Hz
NTSC 4.43/5.5 MHz/50 Hz
NTSC 4.43/6.0 MHz/50 Hz
NTSC 4.43/6.5 MHz/50 Hz
VCR Playback
SECAM-L (French SECAM)
(Using Video-in terminals)
Laserdisc Player Playback
PAL 5.5 MHz/60 Hz
(Using RF-in terminals)
PAL 6.0 MHz/60 Hz
PAL 6.5 MHz/60 Hz
NTSC 3.58/4.5 MHz/50 Hz
Reception Channels
PAL-B/G
VHF
E2–E12 ch
SECAM-B/G
UHF
E21–E69 ch
PAL-D/K
VHF
C1–C12 ch, R1–R12 ch
SECAM-D/K, K1
UHF
C13–C57 ch, R21–R69 ch
PAL-I
VHF
B–J ch
UHF
21–69 ch (Hong Kong)
NTSC
VHF
2–13 ch (U.S), 1–12 ch (Japan)
UHF
14–69 ch (U.S), 13–62 ch (Japan)
CATV
S1–S20 ch, S21–S41 ch (Hyper)
Receiving Frequency
48.25 MHz – 863.25 MHz
Channel Tuning
100-Channel Electronic Tuner with Full Auto Tuning System
Picture Tube
21-Inch Flat CRT
Audio/video input × 2 (front × 1, rear × 1), Audio/video output × 1 (rear),
Terminals
Headphone jack × 1 (front), DVD input (COMPONENT-IN) × 1 (rear)
7.5 W (RMS) × 2, total 15 W (RMS)
Sound Output
Power Source
AC 110 – 240V, 50/60 Hz
Power Consumption
112 W
605 (W) × 468 (H) × 487.5 (D) mm
Dimensions
Weight
22.5 kg (Approx.)
• Design and specifications are subject to change without notice.
• Receiving system: These receiving systems, encompassing all currently available technology, include those with
planned broadcast, videotape and laserdisc hardware and software.
SHARP CORPORATION
SECAM-B/G
SECAM D/K, K1
NTSC-M (NTSC Standard)
NTSC 3.58/5.5 MHz
NTSC 3.58/6.0 MHz
NTSC 3.58/6.5 MHz
SECAM-I (6.0 MHz)
Advertisement
Table of Contents
