Sharp 21H-FX3P Operation Manual page 20

Settings and adjustments
• Switching COLOUR system:
Set the system to "AUTO" for normal TV reception. The AUTO mode automatically detects the receiving
signal system and changes the reception system of the TV set. When the picture is not stable, switching
to an appropriate system may improve the picture quality.
• In a weak reception area, or under bad reception conditions, you can change the frequency by fine tuning.
• When using FINE, the channel number changes from green to yellow.
• To return the channel to its original frequency setting, follow the manual channel tuning procedure.
See 17 .
• Channel setting menu cannot be selected during COMPONENT mode.
E 19
Channel setting (continued)
• AUTO
The AUTO mode screen will appear.
(i) Pressing
MENU/PRESET
screen as shown below.
AUTO MANUAL
(ii) Pressing
again and Auto Channel Tuning
is started.
(Please see page
• FINE (MANUAL)
(i) Each time
to allow fine tuning and the colour of channel number changes to
yellow.
(ii) Press
Channel Tuning" will start. If a signal is found, the Manual
Channel Tuning will stop searching.
• Channel number in Red
• Channel number in Green : Manual Channel Tuning is stop.
6
Press
MENU
screen appears.
• When you select AV1, AV2 for the
channel position, the CH-SETTING
menu changes as shown on the
right and the colour mode changes
in the following order:
AUTO PAL
N358
AUTO(B/G)
VHF
224.25MHz
changes the
NORMAL
SCREEN
/
for details on Auto Channel Tuning.)
16
/ is pressed, the frequency changes
/ for more than 4 seconds, the "Manual
: Manual Channel Tuning is
performing.
Repeat (ii) above to continue Manual
Channel Tuning.
until normal
CH-SETTING
POSITION
COLOUR
SECAM
N443
CH
7
AV1
AUTO
:SELECT
:ADJUST MENU :RETURN