Table of Contents
Advertisement
Executing a Zero Turn
WARNING: When executing a zero turn,
the
tractor
Executing a zero turn while the tractor is
moving can significantly reduce your
control of the tractor and will cause
severe turf defacement to occur.
•
Stop the forward or reverse motion of the tractor
by moving the two drive control levers to neutral.
•
To turn clockwise, slowly move the left control
lever forward while simultaneously moving the
right control lever rearward. See Figure 16.
CLOCKWISE ZERO TURN
Figure 16
•
To turn counterclockwise, slowly move the right
control lever forward while simultaneously moving
the left control lever rearward. See Figure 17.
COUNTERCLOCKWISE ZERO TURN
Figure 17
MUST
BE
STOPPED.
STOPPING THE TRACTOR
•
Move both drive control levers to the neutral
position to stop the motion of the tractor.
•
Push
the
PTO
disengaged position.
•
Use the deck lift handle to raise the deck to its
highest position.
•
If dismounting the tractor, move the drive control
handles fully outward in the neutral position,
engage the parking brake, move the throttle
control lever to the fast position, turn the ignition
switch to "OFF'" and remove the key from the
switch.
DRIVING ON SLOPES
Refer to the SLOPE GAUGE on page 29 to help
determine slopes where you may not operate safely.
WARNING: Do not operate on inclines
with a slope in excess of 15 degrees (a
rise of approximately 2-1/2 feet every 10
feet). The tractor could overturn and
cause serious injury.
•
Always drive across slopes, NEVER UP AND
DOWN.
•
Always turn uphill where possible. Start at the
bottom of a slope and work upward.
•
Always slow down before turning.
•
Avoid turning downhill if possible. Use extra care
and go slowly when turning downhill.
OPERATING THE PTO
Operate the PTO clutch as follows:
•
Move the throttle control lever to approximately
the mid throttle position.
•
Pull the PTO switch upward to the "ENGAGED"
position.
•
Advance the throttle lever to the operating speed
(full engine speed).
•
The operator must remain in the tractor seat at all
times. If the operator should leave the seat
without turning off the power take-off switch, the
tractor's engine will shut off.
•
The PTO clutch cannot be operated when the
tractor is driving in the reverse direction. The
PTO will disengage when both drive control
levers are moved to the reverse position, and will
re-engage when one (or both) control levers are
moved to the neutral or forward position.
17
switch
downward
to
the
Hide quick links:
Advertisement
Table of Contents
