Adjusting The Worktop; Fitting Under A Counter - Zanussi DWS 6726 Instruction Booklet

Adjusting the worktop

You can move the worktop forward or backward by
25 mm in order to align the machine with other
kitchen units.
Simply unscrew the two rear retaining screws,
move the top to the required position and then
retighten the screws.
IN26

Fitting under a counter

(kitchen worktop or sink)
By removing the machine's worktop, you can install
it under a close fitting sink unit or a pre-existing
top, providing the dimensions of the recess
correspond to those shown in the picture.
Proceed as follows:
Remove the machine's worktop by unscrewing the
two rear retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.
Insert the machine after adjusting height and
IN05
levelling with the adjustable feet. When inserting
the machine, ensure that the water inlet and drain
hoses are not kinked or squashed.
43
PFI05GB