Service Air Cleaner; Changing Engine Oil - Craftsman 580.752710 Owner's Manual

6.75 horsepower 2550 psi 2.0 gpm pressure washer cleaning system
Table of Contents

Advertisement

Available languages

Available languages

ChangBng Engine Oil
Change engine oil after the first 5 hours and every
50 hours thereafter. If you are using your pressure
washer under extremely dirty or dusty conditions, or in
extremely hot weather, change oil more often.
CAUTION
• Used motor oil has been shown to cause skin cancer in
certain laboratory animars,
• Thoroughly wash exposed areas with soap and water,
KEEP OUT OF REACH
OF CHILDREN.
DON'T
POLLUTE.
CONSERVE
RESOURCES.
RETURN
USED OiL TO
COLLECTION
CENTERS.
Service
Air Cleaner
Your engine will not run properly and may be
damaged if you run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of
operation or once each year, whichever comes first.
Service more often if operating under dirty or dusty
conditions. Replacements are available at your local
Sears service center.
To service the air cleaner, follow these steps:
1.
Loosen screw and tilt cover down.
Tabs and Slots
-L
Cartridge
Change oil while engBne is still warm from running, as
follows:
1.
Drain fuel tank by running pressure washer until
fuel tank is empty.
2.
Disconnect spark plug wire and keep it away from
spark plug.
3.
Clean area around oil fill, remove oil fill
cap/dipstick. Wipe dipstick clean.
4.
Tip your pressure washer to drain oil from oil fill
into a suitable container making sure you tip your
unit away from spark plug. When crankcase is
empty, return pressure washer to upright position.
5.
Slowly pour recommended
oil (about 20 oz.) into
oil fill opening. Pause to permit oil to settle. Fill to
"Full" mark on dipstick.
6.
Wipe dipstick clean each time oil level is checked.
DO NOT overfill.
7.
Replace and tighten dipstick.
8.
Wipe up any remaining oil.
9.
Reconnect spark plug wire to spark plug.
Base
Cover
2.
Carefully remove cartridge assembly.
3.
To clean cartridge, gently tap pleated paper side
on a flat surface.
4.
Reinstall clean or new cartridge assembly inside
cover.
5.
Insert cover's tabs into slots in bottom of base.
6.
Tilt cover up and tighten screw securely to base.
NOTE: You can purchase new air filter elements by
calling 1-800-366-PART.
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents