Advertisement
ADJUSTING
DEPTH
OF CUT (WITH ROUTER
See Figure 7.
The indicator point on the base can be used when
using your router mounted to a router table.
[] Set the cutter at zero depth of cut.
[] Rotate depth indicator ring to desired depth of cut
on the scale. Refer to "ADJUSTING DEPTH OF
CUT" earlier in this manual.
[] Tighten locking arm securely.
FOR ROUTER TABLE USE ONLY
SPEED SELECTION CHART
CUTTER S_ZE
MATERIAL
1/'4
3/8
1/'2
3/4
SOFT
E-F
D-E
A-B
A
MEDIUM
D-E
C-D
A
A
HARD
C-D
B-C
A
A
VERY HARD D-E C-D C-D
B-C
INDICATOR
POINT
DEPTH
INDICATOR RiNG
DEPTH
ADJUSTMENTRING
Fig. 7
ADJUSTmNG
SPEED
(MODEL
NO. 315.175111)
See Figure 8.
Your router has a variable speed control selector
designed to allow operator control of speed and
torque limits. You can make speed selections best
suited to the type of cut, the material being cut, and
the size of bit being used. The variable speed control
selector allows you to adjust router speed from 15,000
to 25,000 RPM. There is a six-step scale (A to F) on
the variable speed control selector. To increase the
speed and torque of your router, turn the variable
speed control selector to a higher setting (F). Turn to
a lower setting to decrease speed and torque.
NOTE: If you do not want to use the variable speed
control selector, turn it to the highest possible setting,
and the feature will not be active.
The speed selection chart shown gives suggested
speed settings based on the diameter of the cutter
and the type of material being routed.
Fig. 8
11
Advertisement
