Craftsman 917.388220 Owner's Manual page 4

Theseaccessories wereavailable whenthis lawnmowerwasproduced.Theyare also
availableat mostSearsretailoutletsandservicecenters. MostSearsstorescanalso
orderrepairpartsforyou,whenyouprovidethe modelnumber of yourlawnmower.
Someoftheseaccessories maynotapplyto yourlawnmower.
LAWN MOWERPERFORMANCE
CUPPING DEFLECTOR
FOR REAR DISCHARGE LAWN MOWERS
GRASS CATCHERS
FOR
REAR DISCHARGE
LAWN MOWERS
MULCHER lOTS
GRASSCATCHERS
FOR
SIDEDISCHARGE
LAWNMOWERS
STABlUZER
GAS CANS
LAWN MOWER MAINTENANCE
MUFFLERS
BELTS BLADES
AIR RLTERS
BLADE ADAPTERS
WHEELS
SPARK PLUGS
ENGINE OIL
Read these instructions and this manual in • Remove all packing materials except
its entirety before you attempt to assemble
or operate your new lawn mower. Your
new lawn mower has been assembled at
the factory with the exception of those
parts left unassembled for shipping
purposes. All parts such as nuts, washers,
bolts, etc., necessary to complete the
assembly have been placed in the parts
bag. To ensure safe and proper operation MOWER
of your lawn mower, all parts and hardware TO UNFOLD HANDLE
you assemble must be tightened securely.
Use the correct tools as necessary to
ensure proper tightness.
TO REMOVE LAWN MOWER FROM
CARTON
• Remove loose parts included with
mower.
• Cut down two end corners of carton and
lay end panel down flat.
padding between upper and lower
handle and padding holding operator
presence control bar to upper handle.
• Roll lawn mower out of carton and check
carton thoroughly for additional loose
pads.
HOW TO SET UP YOUR LAWN
IMPORTANT: Unfold handle carefully so
as not to pinch or damage control cables.
• Raise handles until lower handle section
locks into place in mowing position.
• Remove protective padding, raise upper
handle section into place on lower
handle and tighten both handle knobs.
• Remove handle padding holding
operator presence control bar to upper
handle.
4