Advertisement
NOTE: Itwilt b enecessary
touse a
deep s ocket totighten the hex nut.
The hex nut m ust becentered inthe
hoIe ofthe cutting head b efore tight-
ening.
7. Tighten nut s ecurely (10-12 f t-lbs).
8. Release Iocking lever.
ATTACHING
SHIELD
,I_WARNING:
The shield must be
property installed. The shield provides
partiaI protection from the risk of thrown
objects to the operator and others and
is equipped with a line Iimiter blade
which cuts excess line to the proper
length, The Iine limiter blade (on under-
side of shield) is sharp and can cut you.
For proper orientation of shietd, see
KNOW YOUR TRIMMER illustration in OP-
ERATION section.
1. Remove wing nut from shield.
2.
Insert bracket into siot as shown.
3.
Pivot shietd until bolt passes
through hote in bracket.
4.
Securely tighten wing nut onto bott.
Shield
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNiT
Compare the illustrations with your unit to familiarize yourseff with the location
of the various controls and adjustments.
Save this manual for future reference.
Tube %,
Trimmer
"
_
ON/STOP Switch
Head
e_a d_
r Handle
/
Throttle
Line Limiter
Trigger
Blade
Muffler
ON/STOP
SWITCH
The ON/STOP switch is used to stop the
engine. To stop the engine,
push and
release the engine ON/STOP switch.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor
and fuel lines and fitis
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing
it and allowing it to return
to its original form.
CHOKE
The CHOKE helps to supply fuel to the
engine to aid in cold starting. Activate
the choke by moving the choke lever to
the FULL CHOKE position. After the en-
gine attempts to start, move the choke
Iever to the HALF CHOKE position. Once
engine has started, move the choke le-
ver to the OFF CHOKE position.
Advertisement
