Check Battery; To Roll Tractor Off Skid; To Drive Tractor Off Skid - Craftsman 917.273396 Owner's Manual

5, Pivot seat and pan forwardand as-
semble adjustmentknoband flat
washer loosely.Do not tighten.
6, Lower seat into operatingpositionand
sit in seat.
7, Slide seat until a comfortableposition
is reachedwhich allowsyou to press
clutch/brakepedal all the way down,
8, Get off seat without movingits ad-
justed position,
9, Raise seat and tightenadjustment
knob securely,
Seat
Shoulder
Bolts
Flat Washer
Adjustment Knob i
CHECK BATTERY
1. Lift seat pan to raised position.
NOTE: If this battery is put into service
after month and year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps. (See "BATTERY" in Maintenance
section of this manual for charging instruc-
tions).
Seat
Label
Terminal
NOTE: You may now roll or drive your
tractor off the skid, Follow the appropriate
instruction below to remove the tractor
from the skid,
TO ROLL TRACTOR OFF SKmD
(See
Operation section for mocation and
function of controls)
1. Press lift lever plunger and raise
attachment lift lever to its highest po-
sition.
2. Release parking brake by depressing
clutch!brake pedal.
3. Place gearshift lever in neutral (N)
position.
4. Roll tractor forward off skid.
5. Remove banding holding deflector
shield up against tractor.
TO DRIVE TRACTOR OFF SKmD (See
Operation section for mocation and
function of controms)
_WARNING: Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
1. Be sure all the above assembly steps
have been completed.
2. Check engine oil level and fill fuel tank
with gasoline.
3. Sit on seat in operating position,
depress clutch/brake pedal and set the
parking brake.
4. Place gear shift lever in neutral (N)
position.
5. Press lift lever plunger and raise
attachment lift lever to its highest posi-
tion.
6. Start the engine. After engine has
started, move throttle control to idle
position.
7. Depress clutch/brake pedal into full
"BRAKE" position and hold. Move gear-
shift lever to Ist gear.
8. Slowly release clutch/brake pedal and
slowly drive tractor off skid.
9. Apply brake to stop tractor, set park-
ing brake and place gearshift lever in
neutral position.
10.Turn ignition key to "STOP" position.
Continue with the instructions that follow.