Quick-Connect Guide
NS-FP9500
Home Cinema Speaker Package
1
In the Box
Inspect Contents After unpacking, inspect the contents to confirm you have the above items:
speakers,
three rear speakers,
one center speaker,
two finishing brackets,
RCA cable, one bag each of
bracket and screw,
subwoofer,
non-skid pads for base,
for base.
3
Main Speaker Assembly
Attach Bases to Stands Apply the non-skid pads
inset. Identify both speaker stands
and both bases
short screws
as shown.
6
Connect Main Speaker Wire For
illustration purposes, stand, which is now
attached to speaker, is not shown in diagram
above. Locate screw-type input terminals
at the rear of each of the speakers. Connect
the speaker wire as shown. The positive
(+) side of the wire with the white stripe
attaches to the red terminal. The negative
(-) side attaches to the black terminal.
(Please see your NS-FP9500 Owner's Manual
for more detailed instructions on speaker
wire connections.) Place assembled main
speakers in desired location to the left and
right of the viewing/audio source. (See Step
2, Room Layout.)
NOTE
Banana plug connectors (not
included) can be used to connect speaker
wire to speaker terminals. Please see your
Owner's Manual for directions.
speaker wire,
two bases,
two speaker stands,
long screws (8) and
short screws (4),
non-skid pads for stands, and
cable protection seal
as shown in the
and attach using
2
two main
Speaker Placement After assembly of the speakers place them so they appear in the approximate positions as
shown in the diagram above.
center speaker
5
���
���
���� �������
8
Attach Finishing Brackets
9
Front Center Speaker Assembly
Attach Bracket and Speaker Wire Attach bracket
speaker
using supplied screw as shown. Attach speaker wire as shown
in Step 6.
Room Layout
on top of two speaker stands.
to center