Gigabyte GA-MA78GM-DS2H User Manual page 83

B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears (RAID hard drive will not be detected at this stage),
select Load Driver. (Figure 6).
Step 2:
Specify the location where the driver is saved (Figure 7). For users using a SATA optical drive, be sure
to copy the driver files from the motherboard driver disk to a USB flash drive before installing Windows
Vista (go to the BootDrv folder and save the whole SB700V foler to the USB flash drive). Then use
Method B to load the driver.
Method A:
Insert the motherboard driver disk into your system and browse to the following directory:
\BootDrv\SB700V\x86
For Windows Vista 64-bit, browse to the x64 folder.
Method B:
Insert the USB flash drive containing the driver files and browse to the x86 (for Windows Vista 32-bit)
or x64 (for Windows Vista 64-bit) folder.
Figure 6
Figure 7
- 83 - Appendix