Craftsman 580.752950 Operator's Manual page 14

Nowto StopYour PressureWasher
1. Releasespray gun trigger and let engine idle for two
minutes.
.
3.
Push engine rocker switch to off position (0 or OFF),
ALWAYS point spray gun in a safe direction, push red
button and squeezespray gun trigger to releaseretained
high water pressure.
_i_WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
• Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
• ALWAYSpointspraygun in safedirection,pressred button
andsqueeze sprayguntriggerto release highpressure, e very
time you stop engine.
Nowto Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun and nozzle extension. There is also a
detachable hose wrap at the front of the accessory tray to
hold your high pressure hose.
1. Placenozzle extension in groove on accessory tray as
shown. Pull rubber strap tight around nozzle extension
and place hole in strap over tab on accessory tray.
Nowto Use Selector Nozzle
The selector nozzle allows you to switch between five
different spray pattern nozzles.Spray patterns can be
changed while pressure washer is running once spray gun
trigger safety lock is engaged.The spray patterns vary as
shown below.
,_, WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
• NEVER changespraypatterns withoutthetriggerlockedon the
spraygun.
• DONOT twist selectornozzle whilespraying.
Follow these instructionsto change nozzle patterns:
1. Select desired spray pattern:
• NAX- For stubborn or hard to reach surface such
as second story surfaces, paint removal,oil stains,
rust removal or other stubborn substances (tar,
gum, grease, wax, etc.).
• GENERAL- For most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc..
• DELICATE- For gentle cleaning of cars/trucks,
boats, RV's, patio furniture, lawn equipment, etc..
• FLUSH- For quick high flow clean up and long
reach cleaning of second story siding and windows.
• SOAP- For general soap applications or to launch
soap to second story siding and windows.
2. Push button on selector nozzle, nozzledial will pop up.
3. Turn dial until desired spray pattern lines up with button
on selector nozzle.
4. Push dial in until it locks into place.
2. Placespray gun in groove on accessory tray as shown.
Pull rubber strap tight around spray gun and place hole in
strap over tab on accessory tray.
3. Wrap high pressure hose on hose wrap then attach hose
wrap to front of accessory tray.
4. Place selector nozzle in hole on Quick Switch
TM
assembly
tray.
Usage Tips
* For most effective cleaning, keep selector nozzle from
8 to 24 inches (20 to 61 cm) away from cleaning surface.
, If you get selector nozzletoo close, especially using a
high pressure spray pattern nozzle,you may damage
surface being cleaned.
, DONOT get closer than 6 inches (15 cm) when cleaning
tires.
14