Replacing The Line - Craftsman WEEDWACKER 358.745340 Operator's Manual

3.8 amp motor 12 inch cutting path / 0.065 in. line
Table of Contents

Advertisement

Available languages

Available languages

MOWING
Your trimmer is ideal for mowing in
places conventional
lawn mowers
cannot reach. In the mowing position,
keep the line parallel to the ground.
Avoid pressing the head into the
ground as this can scalp the ground
and damage the tool.
Mowing
SWEEPING
The fanning action of the rotating line
can be used for a quick and easy
clean up. Keep the line parallel to and
above the surfaces
being swept and
move the tool from side to side.
Sweeping
_'¢_: "_--
CUSTOMER
RESPONSIBILITIES
,_
WARNING:
Disconnect
power source before performing
maintenance.
CARE & MAINTENANCE
TASK
Check for loose fasteners and parts
Check for damaged
or worn parts
Inspect and clean unit and labels
WHEN TO PERFORM
Before each use
Before each use
After each use
GENERAL
RECOMMEN
DATIONS
The warranty on this unit does not cover
items that have been subjected
to oper-
ator abuse or negligence.
To receive full
value from the warranty,
the operator
must maintain
unit as instructed
in this
manual. Various adjustments
will need
to be made
periodically
to properly
maintain
your unit.
BEFORE
EACH
USE
CHECK
FOR LOOSE
FASTENERS
AND PARTS
• Housing Screws
• Locking Sleeve Assembly
• Assist Handle
• Debris Shield
REPLACING
THE LINE
CHECK
FOR DAMAGED
OR
WORN PARTS
Contact
a Sears Service Center for re-
placement
of damaged
or worn parts.
• Trigger Switch - Ensure switch func-
tions properly by pressing and re-
leasing the trigger switch.
Make sure
motor stops.
• Debris Shield - Discontinue
use of
unit if debris shield is damaged.
AFTER
EACH
USE
INSPECT AND CLEAN UNIT AND LA-
BELS
• After each use, inspect complete
unit for loose or damaged
parts.
Clean the unit using a damp cloth
with a mild detergent.
• Wipe off unit with a clean dry cloth.
1. Disconnect
the unit from the power
source.
2.
Remove the spool by firmly pulling
on the tap button.
3.
Clean entire surface of hub and
spool.
4.
Replace with a pre-wound
spool or
cut a length of 30 feet of 0.065"
(1.65 mm) diameter Craftsman®
brand line. Use of heavier lines
could overload and damage
unit.
'Ig&WARNING:
Never use wire,
rope, string, etc., which can break off
and become a dangerous
missile.
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents