Table of Contents
Advertisement
GET TOKNOW
YOUR REMOTE •(MBR3457)
PROGRAMMING
YOUR
REMOTE
If you're using Zenith products, the remote is already programmed for the most common codes: TV = IL01, VCR = 201, CABLE =
353, and AUX = 401. For other brands, or if your remote fails to control your Zenith products, you'll have to program the remote.
:):iii:-i : :_i )i?i;i);:, i
;! i_!;i!i!_ : ;i ;;i
i_i ; _::Ti:;_::i!;:
iii : S: ii
iil
;i iiiili: !_i 7! i! !:.i !i! ;l;
:
ill:!
i
:
:.!:.;
...............
ii:: :.if:::.;
ii:.i :.ii . .................................................................................................
1.
Install the batteries if you have not already done so.
2.
Press and hold _)
using a blunt object.
Indicator light stays on to sho,x you're in the programming
Release PRG after the indicator light turns on.
mode.
3.
Press then release 'the
Indicator light flashes to show:
ready to accept
button for the product
_
@
(_
@
a code.
being programmexl.
4.
Enter 3-digit
.. (_)
(_)
(_)
rvs
vcas
C^B,E
Indicator light flashes for each digit you enter.
®®®
from the chart
@
(_)
(_)
on the next page. (_)
@
5.
Press then release _
to save the code.
Indicator light on remote flash(
and turns off to show your
code was accepted.
/
6.
Point remote at product and press (_
to test the
Product turns On.
product's operation. If it does not turn on, reprogram the
If none of the codes listed for your product operates it,
remote using a dif_erent code listed for your product,
use Auto Find as described bel,
7.
Repeat the above steps to program the remote for another product.
_so-o2-o
8
2
Advertisement
Table of Contents
