Panasonic Viera TC-L47DT50 Owner's Manual page 9

Accessories
Assembly screws
® XSSS+lSFNK ® XYN4+F10FJK XYN4+F10FJK
(black) (black) (black)
size (MS x 15) (4) size (M4 x 10) (4) size (M4 x 10) (2)
(includedwith Cover)
Bracket (1)
® TBL5ZA30091
Cover (1) Base (1)
® TBL5ZB30091 ® TBL5ZX0252
Two people are always required for attachment.
[] Preparation for assembly
Unpack the pedestal and the TV, turn them so that their
front surfaces face down, and put them on a blanket or
such other cloth spread out on a workbench or desk.
® Turn the front side of package to the workbench when
unpacking the TV.
® Choose a stable workbench which is larger than the TV
and use a clean blanket or cloth which has no dirt or
foreign matter on it.
® Do not hold the LCD panel when holding the TV.
® Be careful not to scratch or damage the TV.
•Assembling the pedestal
_ Attach the Bracket to the protrusion of Neck.
® Make sure that the bracket is anchored before fixing the
screws.
® Fix securely with assembly screws @ (4 screws)
Protrusion of Neck (top)
Hold the
bracket
not to fall over
Front
[]Set-up
_ Attach the pedestal
® Align the three tabs
on the bracket with
the grooves on the
back of the TV and
insert them.
® Check that the center
tab is in the hole, and
then slide in the bracket
so that the arrow (._)on
the back of the TV is
aligned with the arrow
(t) on the bracket.
_ Tighten assembly
screws _ (total 4
screws) loosely at
first, then tighten them
firmly to fix securely.
of the TV
@_Attach the bracket cover
® Attach the bracket cover and fix securely
with assembly screw _C_ (total 2 screws).
® Tighten screws firmly.
TV
_3_Set the pedestal
® As shown in the figure, two people should hold the specified portions of
the TV, raise and set up the TV.
Hold here
9