column and base
components and Hardware needed:
Base ...................................................................1
Column ...............................................................1
hex Bolts M10-1.5 x 25 ......................................4
the column must be secured on the base to
properly assemble your drill press.
To secure the column to the base:
1.
place the column on the base and align the
mounting holes.
2.
secure the column to the base with the four
hex bolts, as shown in figure 6.
figure 6. Column secured to base.
Model g7943/g7944 (Mfg. 10/02+)
Table Support
Qty
components and Hardware needed:
table support assembly ................................... 1
Crank handle .................................................... 1
handle ............................................................... 1
large lock lever ............................................... 1
small lock lever ............................................... 1
the table support must be installed as described
to properly assemble your drill press.
To install the table support:
1.
Check to make sure the pinion is inserted
into the table support, as shown in figure 7,
so the pinion and gear teeth mesh together.
figure 7. pinion correctly installed in table
support.
Qty
-17-