Creating A Bluetooth Cell Phone Key - Gigabyte GA-EG45M-DS2H User Manual

Step 3:
Enter the TPM User Password that you set earlier and click OK to complete creating the USB key. You are
able to access/close your PSD by plugging in or unplugging the USB flash drive.
• If you enter the TPM User Password incorrectly three times, Smart TPM will be locked. To be able to
enter the password again, go to the "Security Chip Configuration" menu in BIOS Setup and then set
"Security Chip" to "Enabled/Activate."
• When you unplug the USB key, the Infineon Security Platform Settings Tool will give the following warning
message, which is normal.
To cancel a USB key:
To cancel a USB key, uncheck the USB flash drive that has been configured as the Smart TPM user key on
the Configure USB Storages tab. When prompted to confirm, click Yes. Then the USB key is cancelled.
4.2. Creating a Bluetooth Cell Phone Key
Step 1:
To create a portable Bluetooth cell phone key, select Configure BT Devices and then select the Bluetooth
cell phone that you want to use as the portable user key. (If the screen doesn't display your Bluetooth-enabled
cell phone, click Refresh to let Smart TPM re-detect the device.)
Before creating a Bluetooth cell phone key, make sure your motherboard includes a Bluetooth receiver and
turn on the search and Bluetooth functions on your phone.
Do not turn off or reset your computer when a USB key is being cre-
ated.
- 19 -