Epson LQ-1010 User Manual page 125

Characters
User-defined
This example of a character definition program should make this clear:
In line ESC x0 command selects draft printing.
10,
the
The actual character definition starts in line 20. The two @ signs in line
30 represent n1 and n2, the range of characters being defined (in this
case, a range of
The information about the actual character design (which is contained
in the DATA statements at the end of the program) is sent to the printer
in the loop between lines
Note: When defining Letter Quality or proportional characters, put
a WIDTH statement in your program to prevent carriage return and
line feed codes from interfering with your definitions.
4-26
Software and Graphics
10 LPRINT CHR$(27)"x0"
20 LPRINT CHR$(27)"&"CHR$(0);
LPRINT '@@";
30
40 LPRINT CHR$(l)CHR$(9)CHR$(l);
50 FOR I=1 TO 27
60 READ-A: LPRINT CHR$(A);
NEXT I
70
80 LPRINT "@@@@@"
90 LPRINT CHR$(27)"%"CHR$(1);
100 LPRINT "@@@@@"
110 LPRINT CHR$(27)"%"CHR$(0);
120 LPRINT "@@@@@"
130 END
140 DATA
1,0,0,2,0,0,4,0,0
150 DATA
8,0,0,23,255,240,8,0,0
160 DATA
4,0,0,2,0,0,1,0,0
Line contains d0, d1, and d2.
1). 40
and
50 70.