Weslo AIR STRIDER User Manual page 5

2, Refer to figure 2b, Slide a Finger Guard (54) onto
the pinson the LeftPivotBracket(7). Note:The
Finger Guards may already be attached.
Find the Left Unk Arm (11), which is labeled with a
"leff' sticker. Make sure that there are two 3/8"
Bushings (16) in each end of the Link Arm. Slide
one end of the L{nk Arm onto the indicated pin on
the Left PJvot Bracket (7). Make sure that the Link
Arm Is turned as shown In figure 2c, Tap a 3/8"
Axle Cap (40) onto the pin. Slide the other end of
the Link Arm onto the pin on the Rocker Arm (9).
(Note: It may he necessary to pivot the Rocker Arm
and the Left Leg [1] slightly.) Tap a 3/8" Axle Gap
(40) onto the pin.
Attach the other Finger Guard and the Right Link
Arm (not shown) in the same manner.
3. Attach the Right Frame Section (5) to the Right
Uprighf (2) with a 3/8" Screw (42), a Plastic
Spacer (41), and a 3/8" Nylon Locknut (43). Do
not tighten the Nylon Locknut yet,
4. Slide the Hip Pad (28) onlo the Left Frame
Section (5). Make sure that the indicated hole is
accessible.
Slide the Left and Right Frame Sections (5, 6)
together. Attach the Frame Sectlons with two #8 x
3/4" Screws (23). Do not tighten the Screws
yet.
Attach the Left Frame Section (5) to the Left
Upright (1) with a 3/8" Screw (42), a Plasftc
Spacer (41), and a 3/8" Nylon Locknot (43),
Tighten all parts used in steps % 3, and 4.
Slide the Hip Pad (28) so it is centered on the
Frame Sections (5, 6).
Pin 16 _/-40
.7 Pin
//1
• Fig 2b J'_.7
Fig. 2o Long
Side I
"11 Pin 7
Fig. 4 6
4_/_'il _i' , ' "\\\\\!,\
5