Advertisement
TROUBLESHOOTmNG
Most treadmill
problems
can be solved by following
the instructions
below, if further assistance
is
needed, please call our Customer
Service Department
toll-free at 1-866-699-3750,
Monday through
Friday,
6 a.m. until 6 p.m. Mountain
Time (excluding
holidays).
PROBLEM:
The power does not turn on
SOLUTmON: a, Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 10), Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 10, important: The treadmill is not com-
patible with GFCI-equipped
outlets,
b, Make sure that the key is fully inserted into the console,
C,
Check the reset/off circuit breaker located on the frame near the
power cord, if the breaker protrudes as shown, the circuit breaker
has tripped, To reset the circuit breaker, wait for five minutes and
then press the breaker back in,
PROBLEM:
The power turns off dudng use
Off
Reset
SOLUTION:
a, Check the reset/off circuit breaker located on the treadmill frame near the power cord (see 1, c,
above), if the circuit breaker has tripped, wait for five minutes and then press the switch back in,
b, Make sure that the power cord is plugged in, if the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in,
s, Remove the key from the console and then reinsert it,
PROBLEM:
The disptays of the consote
do not function
propedy
SOLUTION:
a, Remove the key from the console and UNPLUG THE
POWER CORD. With the help of a second person,
carefully tip the Base (109) down as shown, Remove
the four Long Belly Pan Screws (121), Note: A phillips
screwdriver with at bast a 5" shaft is required,
121
With the help of a second person, carefully raise the
Upright (82) as shown, Carefully pivot the Hood (89)
off,
i/
39
/i I
22
Advertisement
