Canon POWERSHOT SX160 IS Getting Started Manual page 2

CaHOH
* Before using the product, please ensure that you read the safety precautions described below.
Always ensure that the product is used correctly.
* The safety precautions noted on the following pages are intended to prevent injuries to yourself and
other persons, or damage to the equipment.
* Do not trigger the flash in close proximity to people's eyes.
Exposure to the intense light produced by the flash could damage eyesight, in particular, remain at
least 1 meter (39 inches) away from infants when using the flash.
* Store this equipment out of the reach of children and infants.
Strap: Putting the strap around a child's neck could result in asphyxiation.
Date/time battery (if removable): Dangerous if swallowed, if this occurs, contact a doctor immediately.
* Use only recommended power sources.
* Do not attempt to disassemble, alter or apply heat to the product.
* Avoid dropping or subjecting the product to severe impacts.
* To avoid the risk of injury, do not touch the interior of the product if it has been dropped or
otherwise damaged.
* Stop using the product immediately if it emits smoke, a strange smell, or otherwise behaves
abnormally.
* Do not use organic solvents such as alcohol, benzine, or thinner to clean the product.
* Do not let the product come into contact with water (e.g. sea water) or other liquids.
* Do not allow liquids or foreign objects to enter the camera.
This could result in electrical shock or fire.
if liquids or foreign objects come into contact with the camera interior, immediately turn the camera
off and remove the battery/batteries.
if the battery charger (for cameras that use one) becomes wet, unplug it from the outlet and consult
your camera distributor or a Canon Customer Support Help Desk.
* Do not look through the viewfinder (if your model has one) at bright light sources, such as
the sun on a clear day.
This could damage your eyesight.
* Use only the recommended battery/batteries.
* Do not place the battery/batteries near or in direct flame.
* tf your camera uses a battery charger, note the following precautions.
-Unplug the power cord periodically, and using a dry cloth, wipe away any dust and dirt that has
collected on the plug, the exterior of the power outlet, and the surrounding area.
- Do not handle the power cord with wet hands.
- Do not use the equipment in a manner that exceeds the rated capacity of the electrical outlet or
wiring accessories. Do not use if the power cord or plug are damaged, or not fully plugged into the
outlet.
- Do not allow dirt or metal objects (such as pins or keys) to contact the terminals or plug.
The battery/batteries may explode or !eak, resulting in electrical shock or fire. This could cause injury
and damage the surroundings, in the event that a battery leaks and the battery electrolyte contacts
eyes, mouth, skin or clothing, immediately flush with water.
* Turn the camera off in places where camera use is prohibited.
The electromagnetic waves emitted by the camera may interfere with the operation of electronic
instruments and other devices. Exercise adequate caution when using the camera in places where
use of electronic devices is restricted, such as inside airplanes and medical facilities.
* Do not play any included CD-ROMs in a CD player that does not support data CD-ROMs.
it is possible to suffer hearing loss from listening with headphones to the loud sounds of a CD-ROM
played on an audio CD player (music player). Additionally, this could damage the speakers.
* When holding the camera by the strap, be careful not to bang it, subject it to strong impacts
or shocks, or let it get caught on other objects.
* Be careful not to bump or push strongly on the lens.
This could lead to injury or damage the camera.
* Be careful not to subject the screen to strong impacts.
if the screen cracks, injury may result from the broken fragments.
* When using the flash, be careful not to cover it with your fingers or clothing.
This could result in burns or damage to the flash.
* Avoid using, placing or storing the product in the following places:
- Places subject to strong sunlight
-Places subject to temperatures above 40 °C (104 °F)
- Humid or dusty areas
These could cause leakage, overheating or an explosion of the battery/batteries, resulting in electrical
shock, fire, burns or other injuries.
High temperatures may deform the product.
* The slideshow transition effects may cause discomfort when viewed for prolonged periods.
* When using optional lenses, lens filters, or filter adapters (if applicable), be sure to attach
these accessories firmly.
if the lens becomes loose and falls off, it may crack, and the shards of glass may lead to cuts.
* On cameras that raise and lower the flash automaticaffy, make sure your finger is out of the
way when the flash is lowered, to avoid pinching it.
This could result in injury.
* Do not aim the camera at bright light sources (such as the sun on a clear day).
Doing so may damage the image sensor.
* When using the camera on a beach or at a windy location, be careful not to allow dust or
sand to enter the camera.
* On cameras that raise and lower the flash automatically, do not push the flash down or pry
it open.
This may cause the product to malfunction.
* In regular use, small amounts of smoke may be emitted from the flash.
This is due to the high intensity of the flash burning dust and foreign materials stuck to the front of the
unit. Please use a cotton swab to remove dirt, dust or other foreign matter from the flash to prevent
heat build-up and damage to the unit.
* Remove and store the battery/batteries when you are not using the camera.
if the battery/batteries is/are left inside the camera, damage caused by leakage may occur.
* Before you discard the battery/batteries, cover the terminals with tape or other insulators.
Contacting other metal materials may lead to fire or explosions.
* if your camera uses a battery and battery charger, note the following precautions.
- Unplug the battery charger from the power outlet after charging is complete, or when you are not
using it.
- Do not place anything, such as cloth, on top of the battery charger while it is charging.
Leaving the unit plugged in for a long period of time may cause it to overheat and distort, resulting in
fire.
* Do not place the battery near pets.
Pets biting the battery could cause leakage, overheating or explosion, resulting in fire or damage.
* tf your camera uses multiple batteries, note the foffowing precautions.
-Do not charge batteries of different types at the same time, or use older batteries together with
newer batteries.
- Do not insert the batteries with the + and - terminals reversed.
This may cause the product to malfunction.
* When putting the camera in your bag, ensure that hard objects do not come into contact
with the screen. Also close the screen (so that it faces the camera body), if your camera has
a screen that closes.
* Do not attach any hard objects to the camera.
Doing so may cause malfunctions or damage the screen.
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
* Take and review some test shots initially to make sure the images were recorded correctly. Please
note that Canon inc., its subsidiaries and affiliates, and its distributors are not liable for any
consequential damages arising from any malfunction of a camera or accessory, including memory
cards, that results in the failure of an image to be recorded or to be recorded in a way that is
machine readable.
* images recorded by the camera are intended for personal use. Refrain from unauthorized recording
that infringes on copyright law, and note that even for personal use, photography may contravene
copyright or other legal rights at some performances or exhibitions, or in some commercial settings.
* The camera warranty is valid only in the area of purchase, in case of camera problems while
abroad, return to the area of purchase before contacting a Canon Customer Support Help Desk.
* Although the LCD monitor is produced under extremely high-precision manufacturing conditions
and more than 99.99% of the pixels meet design specifications, in rare cases some pixels may be
defective or may appear as red or black dots. This does not indicate camera damage or affect
recorded images. This also applies to viewfinders, on applicable cameras.
* The LCD monitor may be covered with a thin plastic film for protection against scratches during
shipment, if covered, remove the film before using the camera.
* When the camera is used over an extended period, it may become warm. This does not indicate
damage.
This product is designed to achieve excellent performance when used with genuine Canon
accessories.
Canon shall not be liable for any damage to this product and/or accidents such as fire, etc., caused
by the malfunction of non-genuine Canon accessories (e.g., a leakage and/or explosion of a battery
pack). Please note that this warranty does not apply to repairs arising out of the malfunction of non-
genuine Canon accessories, although you may request such repairs on a chargeable basis.