Content 1. Introduction 2. Hardware and Software Requirements 3. Software Installation and Setup of Access through Internet 4G Service 4. Software Installation and Setup of Access through GPRS/EDGE 5. Main Window 6. Connection and Disconnection 7. WLAN Settings 8. Sending SMS 9.
(see step 7 in Section 4 below). Should your device be missing in the list, it is possible to If you decide to use the T-Mobile Communication Centre, you do not upgrade the software by clicking on Aktualizace programu (Software have to spend time by installing the modem and configuring your Update) in Nastavení...
2. Hardware and Software Requirements Minimal PC Configuration for a 4G Modem Minimal Hardware Configuration: Pentium-class II processor (300 MHz) 64 MB RAM (128 MB recommended) 10 MB of free disk space USB connector or Ethernet port (for optional cable) CD-ROM drive Supported Operating Systems: Microsoft Windows 98 (SE)
3. Software Installation and Setup of Access through Internet 4G Service Insert the installation CD into your computer and in displayed Step 3 menu select T-Mobile Communication Centre installation according to prefered language (Czech/English) or run the installation package downloaded from www.t-mobile.cz/tmcc. Step 1...
Page 6
Step 5 Step 7 The application is now installed in your computer. The wizard continues with the installation of the device. The T-Mobile Communication Centre will guide you through the process of connected device detection. The detection usually takes several seconds.
4. Software Installation and Setup of Access through GPRS/EDGE Insert the installation CD into your computer and in displayed Step 3 menu select T-Mobile Communication Centre installation according to prefered language (Czech/English) or run the installation package downloaded from www.t-mobile.cz/tmcc. Step 1...
Page 8
Step 7 The list of supported devices will be shown. If your device purchased within the sales network of T-Mobile Czech Republic a.s. is not included in the list, it is possible to upgrade the software by clicking on Software Update in Settings menu available after clicking on the...
Page 9
Step 8 The T-Mobile Communication Centre will detect the connected device. The detection usually takes several seconds. When your device is visible in the list, select it by clicking the mouse and press Finish. In the event of any problems with the detection we recommend that you press Back button, disconnect the device, reconnect it again and repeat the detection process.
Internet. If the software has just been installed, only one device will be shown here (or other modems previously installed in the computer). T-Mobile Communication Centre allows you to have multiple devices installed in your computer simultaneously (see Section 9) and to choose the one you need for current connection from the pull-down menu.
If you use and have multiple to possible problems with some Windows configurations. When devices installed in the T-Mobile Communication Centre, it is possible the PIN code request on the SIM card is off, it is enough to install to send SMS messages through another device.
The customer can enter his/her name and password obtained within the framework of the T-Mobile HotSpot service and log into the network by clicking on Login. Name and password are stored for future use. You can log off the T-Mobile HotSpot service by clicking the Log off button.
You can send SMS messages using the devices installed with You can write the message of up to 160 characters in the text field. T-Mobile Communication Centre. The messages will be sent in the Right to that you can input the phone number of the recipient or you...
9. Network Selection and Logging-Off the Network T-Mobile Communication Centre enables the users of an EDGE/GPRS modem (PCMCIA card, external modem) with the possibility of automatic or manual network selection and logging-off the network without having to remove the SIM card from their data device.
10. Device Management Installation of new equipment Uninstalling the device Press the Settings button, select Add new mobile equipment option Select the device which you want to uninstall in the menu in the main and press Next button. window. Press the button for uninstalling. The window with confirmation message will be displayed.
If you do not want to use any other but default connection in the Select Add new connection (APN,…) for new ME adding option. T-Mobile Communication Centre (Internet connection through GPRS APN Internet – this applies in particular to business customers with...
Page 17
Step 4 New APN will be saved. Press Close. Note: Considering the limitations inherent in some Windows versions, the new APN will be available for newly installed devices only. Should you require such APN for previously installed devices, it is necessary to remove the device and add it again in order to set the new APN (see Section 9).
Page 18
Step 2 Step 4 Select Remove connection for new ME adding option. Press Close. Press Next. Note: Considering the limitations inherent in some Windows Step 3 versions, the removed APN will be available for existing devices until you remove the particular device and add it again (see Section 8).
– but you don’t need it if you connect via T-Mobile Communication Centre. We recommend to install Option It is possible to use this file if you are going to install T-Mobile manager only if you are going to use e.g. voice functions of the Communication Centre on other computers with the same card).
13. Abbreviations Abbreviation Full Wording Meaning Access Point Name Access point name Compact disk Data carrier GPRS General Packet Radio Service Technology of fast mobile data transmission Global System for Mobile Communications Mobile telephone network Infra Red Infrared port Personal Computer Personal computer Short Message Service Short text message service...
Need help?
Do you have a question about the Communication Centre and is the answer not in the manual?
Questions and answers