Sony HDW-1800 Operation Manual page 96

Item number Item name
743 P LEVEL (HD)
R
745 SETUP LEVEL (HD)
746 SYNC PHASE (HD)
747 SYNC PHASE FINE (HD)
Item number Item name
801 DIGITAL JOG SOUND
802 DIGITAL AUD MUTING IN
SHUTTLE MODE
803 DIGITAL AUDIO FADE
TIME
805 AUDIO MONITOR
OUTPUT MIXING
806 LEVEL METER SCALE
807 AUDIO OUTPUT PHASE
96
9-4 Items in the Extended Setup Menu
Menu items in the range 700 to 799, relating to video control (continued)
Settings
Adjust the P
OUTPUT connector.
0.0% (0H) to 100% (800H) to 141.3% (B4EH)
Adjust the setup level of the high-definition video signal output from the HDSDI
OUTPUT connector.
0 to 110H to 220H
Control the H sync phase of the high-definition video signal output from the HDSDI
OUTPUT connector according to the menu.
0 to 80H to FFH
Fine control the H sync phase of the high-definition video signal output from the
HDSDI OUTPUT connector according to the menu.
0 to 3FFH
Menu items in the range 800 to 899, relating to audio control
Settings
Turns the digital jog sound on and off.
OFF: Digital jog sound is turned off.
Audio of digital channels not subjected to speed correction is output. When the
tape stops, after one second the audio is muted.
ON: Digital jog sound is turned on.
When the tape speed is in the range x–1 to x+1, speed correction is carried out,
and the same jog sound as a conventional analog VTR is output.
Set the digital audio muting conditions during shuttle playback.
OFF: Not muted.
CUEUP: Muted during cueup or preroll operations.
FULL: Muted in shuttle mode.
Specify the time for cross-fade or fade in/out editing of digital audio signals.
5ms, 10ms, 15ms, 20ms, 25ms
Note
The cross-fade or fade in/out operation means that the recording is rewritten from
the OUT point for the length specified by this setting. Even at the minimum 5ms
setting, a length of recording corresponding to a field is rewritten.
To avoid rewriting, set menu item 317 "AUDIO EDIT MODE" to "CUT". In this case
there is an audio discontinuity at the edit point. There is no effect on the recorded
video signal.
Select the audio mixing method used for digital audio signals supplied to the
MONITOR OUTPUT connector.
ADD: Simple addition
RMS: Root-mean-square
AVE: Simple average
Select the digital audio level display mode.
PEAK0: Display the audio level as negative values with the maximum level set to
"0 dB".
REF.0: Display the audio level as positive and negative values with the reference
level set to "0 dB".
Select the output timing of digital audio playback signals (HDSDI, SDI and AES/
EBU only). The reference position is 80H; when the setting is less than 80H, the
output timing is advanced, and when it is higher than 80H, the output timing is
delayed. (at 80H, 128 samples = approx. 2.7 ms, and 1 sample = approx. 20 µs)
0 to 80 to FF: Set in this range.
level of the high-definition video signal output from the HDSDI
R
a) b)
, 50ms
c)
, 85ms, 115ms