How To Disassemble And Assemble; Door - LG LRTN19314TT Service Manual

HOW TO DISASSEMBLE AND ASSEMBLE

1. DOOR

1) Remove lower cover and then disconnect water
supply tube in the lower part of freezer door.
• Pull the water supply tube
the coupling as shown in the drawing.
2
w
Disconnecting the tube under the door causes about
1.5 litters water to flow out. Please put up a big
container to prevent it.
2) Remove a freezer door.
(1) Loosen hinge cover screw of freezer door and remove
cover.
Disconnect all connecting lines except grounding cord.
Hinge Cover
(2) Turn hinge lever in arrow A direction until it is
loosened and take it out in arrow B direction.
Hinge Lever
A
B
Note : • When disconnecting refrigerator door, turn hinge
lever counterclockwise.
• If the hinge or bracket are bent during assembly,
use two extra screws (Tap Tite M6, Left Hinge
attaching screw) in the holes of the upper hinge.
forward while pressing on
1
Connecting
Line
2
Earthing
Cord
(3) Disconnect upper hinge
by grasping the front part of upper hinge and lifting up
(Hinge Assembly, U) in arrow direction A and pull
forward in arrow B direction. Be careful because the
door may fall, damaging the door, the floor, or injuring
you.
A
(4) Lift up the freezer door
disconnect the door from the lower hinge
the door forward.
1
2
Note : • Lift up the freezer door until a water supply tube is
fully taken out.
(5) Assembly is the reverse order of disassembly
- 100 -
from the hinge supporter
1
2
B
A
in arrow direction and
. Don't pull