Craftsman 917.288660 Operator's Manual page 31

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center.
PROBLEM CAUSE CORRECTION
Battery will not 1 Bad battery cell(s). 1 Replace battery.
charge
2 Poor cable connections. 2 Check/clean all connections.
Loss of drive
3 Faulty regulator (if so equipped).
4 Faulty alternator.
1 Freewheel control in
"DISENGAGED" position.
2 Debris on steering plate (if
equipped).
3 Motion drive belt worn, damaged,
or broken.
3 Replace regulator.
4 Replace alternator.
1 Place freewheel control in
"ENGAGED" position.
2 See "CLEANING" in the
maintenance section.
3 Replace motion drive belt.
4 Air trapped in transmission during 4 Purge transmission.
shipment or servicing.
5 Axle key missing. 5 Install axle key at rear wheel. See
"TO REMOVE WHEEL" in the
Service and Adjustments section.
Engine "backfires"
when turning
engine "OFF"
1 Engine throttle control not set 1 Move throttlecontrol between
between half and full speed (fast) half and full speed (fast) position
position before stopping engine, before stopping engine.
Engine dies when 1 Reverseo,peration system (ROS) 1 Turn ignition key to ROS "ON"
tractor is shifted is not ON'while mower or other position. See Operation section.
into reverse attachment is engaged.
.EED*ORE LP.
Yo_att find the answe<r and more on maaagemyAemeo{em - [or [ree!
i Find this and a[[ your other product manuals online.
oGet a nswers from our t eam ofhome experts.
o 6eta personatized maintenance ptan for your home.
Find information and tools to help with home projects.
aHage ho e !:
broaght to yon by Sears
31