Advertisement
Update...
AMI 493 RAID controller firmware
update and drive installation
If you add a new hard drive to an existing array that has an
AMI 493 controller (firmware version B147 or older), the
Power Console Plus software will scan the drive in a
continuous loop.
To remedy this situation, do one of the following:
Use the interim solution to install a new drive, perform
a migration, or create a new array.
- OR -
Update the controller firmware to version B148 or greater.
The firmware update is located on the technical support
page on the www.gatewayatwork.com Web site.
Important
Interim solution:
1
Turn off the server.
2
Install the new hard drive.
3
Turn on the server.
4
During the server startup procedure, press C
the WebBIOS utility and perform the RAID migration or
create another array for the new drive.
5
When done, exit WebBIOS, then reboot the server.
If the firmware is not available, perform the interim solution.
+H to open
TRL
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Gateway AMI 493
- Page 1 Update... AMI 493 RAID controller firmware update and drive installation If you add a new hard drive to an existing array that has an AMI 493 controller (firmware version B147 or older), the Power Console Plus software will scan the drive in a continuous loop.
- Page 2 To update the AMI 493 RAID controller firmware: Reboot the server and write down the controller firmware version when it appears on the screen. Go to the gatewayatwork.com Web site. At the top of the page, select the link. Under Technical Support Driver , click the...
Need help?
Do you have a question about the AMI 493 and is the answer not in the manual?
Questions and answers