Sears Craftsman 917.251570 Owner's Manual page 7

ASSEMBLY
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes°
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness,
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are }isted.
(2) 7/16" wrenches Tire pressure gauge
(1) 1/2" wrench Utility knife
(2) 9/16" wrenches (1) 3/4" wrench
(t) 3/4" socket with drive ratchet
When right or left hand is mentioned in this manual, it
means when you are in the operating position (seated
behind the steering wheel),.
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
- Remove all accessible loose parts and parts cartons
from carton (See page 6).
= Cut, from top to bottom, along lines on all four comers
of carton, and lay panels fiat.
= Check for any additional loose parts or cartons and
remove,
BEFORE ROLLING TRACTOR OFFSKSD
ATTACH STEERING WHEEL (See Fig. 1)
° Remove hex bolt, lock washer and large flat washer
from steering shaft.
= Position front wheels of the tractor so they are pointing
straight forward_
= Slide the steering sleeve over the steering shaft.
° Position steering wheel so cross bars are horizontal
(left to right) and slide onto steering wheel adapter.
° Secure steering wheel to steering shaft with hex bolt,
lock washer and large fiat washer previously removed.
Tighten securely.
o Snap steering wheel insert into center of steering
wheel.
• Remove protective plastic from tractor hood and grill,.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES
iN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR
IS TO ROLL OFF SKID..
_ TEERtNG WHEEL
INSERT
ti_,_ HEX BOLT
_! LOCK
b_ J WASHER
_'_ _'_- LARGE FLAT
STEERING
STEERING _,,_,_
WHEEL
ADAPTER _,_
//' i
1 / #t
I I It
L
STEERING SHAFT
/
/
/
I
FIG, 1
TO ROLL TRACTOR OFF SKID (See Opera-
tion section for location and function of con-
trols)
o Press lift lever plunger and raise attachment lift lever to
its highest position.
, Release parking brake by depressing clutch/brake
pedal°
, Place freewheel control in freewheeling position to
disengage transmission (See 'q'O TRANSPORT" in
the Operation section of this manual)..
, Roll tractor forward off skid°
• Remove mower and packing materials.
• Remove ties from V-belts..