Table of Contents
Advertisement
ASSE
LY
TO ASSEMBLE
AND ATTACH
GRASS
CATCHER
(See Figs. 3A thru 4)
.
To assemble tubular frame to grass bag, work sewn
hem of bag out through the front opening of bag to
expose the hem.
°
Thread tubular frame into hem and gather material at
top of frame as shown.
Push frame inside bag through the opening until only
the ends of frame are exposed out of the front.
NOTE:
Do not close the flip lid at this time.
Assemble lower frame to tubular frame as shown. Be
sure frames are fully seated together as shown in inset.
Slip viny! bindings over frame.
NOTE:
If vinyl bindings are too stiff, hold them in warm
water for a few minutes.
If bag gets wet, let it dry before
using.
-
Close the flip Iid. Flip lid must be closed while operating
lawn mower.
-
Lift the rear door oll the mower housing and place the
grass catcher frame onto the formed tabs on the rear
door hinge bracket.
The grass catcher
is secured to the lawn mower
housing when the rear door is lowered onto the grass
catcher frame.
FLIP LID
SEWN
HEM
(Pull out
through
front
of opening)
F[Go 3A
SEWN
HEM
F[Go 3B
TUBULAR
FRAME
(Push inside
bag)
RG. 3C
\
HINGE
FIG. 3E
DOOR
FORMED
TABS
GRASS CATCHER FRAME
FiG. 4
7
Advertisement
Table of Contents
