Table of Contents
Advertisement
Installing Shut-off Valve
(not included on some models)
Apply a small amount of pipe sealant to the tapered pipe
th read s on the adapter and tig hen into the man ifold. Install
the swivel connection
end of the shut-off valve to the
straight threaded end of the adapter (pipe sealant is not
required) and tighten this connection. See photo.
REMOVAL OF SHIPPING
BOARDS AND
INSTALLATION
OF RUBBER FEET
(not included on some models)
.
It may be necessary to brace or support
one end of the outfit when attaching the
wheels,
wheel
plates,
and the rubber
foot strip, because the air compressor
will have a tendency
to tip,
Tip the air compressor toward the intake muffler side.
Remove (2) screws with washers securing the upper
shipping board with 3/8" socket wrench. Reusethe (2)
screws to attach (2) of the rubber feet. Tighten se-
curely.
.
Carefully remove (2) screws with washers securing the
lower shipping board.
Supporting
the outfit at this
point may be necessary to prevent tipping.
Again
reuse the (2) screws to attach the remaining (2) rubber
feet. Tighten securely.
3.
Discard the (2) shipping boards and (4) washers.
INSTALLATION
BREAK-IN
PROCEDURES
Location
of the Air Compressor
Locate the air compressor
in a clean, dry and well
ventilated
area.
The air filter must be kept clear of
obstructions
which could reduce air delivery of the air
compressor.
The air compressor
should be located at
least 12" away from the wall or other obstructionsthat
will
interfere with the flowof air. The air compressor head and
shroud are designed to allow for proper cooling.
If humidity is high, a Sears air filter can be installed on the
air outlet adapter to remove excessive moisture. Follow
the instructions
packaged with the air filter for proper
installation.
Lubrication
and Oil
This unit needs no lubrication or oiling.
Hide quick links:
Advertisement
Table of Contents
