Sears Craftsman 358.352030 Owner's Manual page 15

OPTIONAL TEMPERATURE LIMITING MUFFLER COVER
In some states, such as California, laws covering chain saws (having internal combustion engines),
when used in areas covered by forests, brush or grass (excluding residential lawns and landscaped
areas}, necessitate fitting the saw's muffler with an additional heat shield to reduce muffler surface
temperatures. Sears offers such a shietd as an optional aCcessory kit. Order Muffler Heat Shield
Accessory Kit as listed below. Check" with your state conservation or forestry department about
their regulations before operating this Sears chain saw on any forest-covered, brush-covered, or
grass-covered areas Oregon & Washington have similar requirements with respect to forest-
covered lands.
5,EA6, ,CHAIN SAW
MUFFLER HEAT SH[E,L D KIT
358.352030, 352060, 352070
PART NO,-32 36151
The mufflers on the above chain sawsare equipped with a "spark arrestor" to help prevent exhaust
sparks from igniting flammable materials. Some states, such as California, require individuals using
this chain saw in areas covered by forests, brush, or grass (excludingresidentiat lawns and landscaped
areas) to maintain the "spark arrestor" in effective Working order. Instructions covering proper
maintenance and replacement are contained in your Owner's Manual..
INSTRUCTIONS FOR INSTALLING
TEMPERATURE LIMITING MUFFLER COVER
R.EMOVE STANDARD COVER
1. Use a 5/16" socket wrench to remove the
screw located in the center of the muffler cover.
Remove the muller cover from the muffler body
.(figure 1.) Do not remove inside parts.
INSTALL VENT COVER
2_ Insert the temperature limiting muffler cover
(figure 2.) into the muffler body until it seats on
the inside parts, Replace and tighten screw. Do not
use an air wrench to tighten screw.
NOTE:
It is not necessary to remove ins{de muffler
parts to install temperature limiting muffler cover.
If inside parts are removed, the diagram shows how
parts are reassembled.
Figure 2
.,. , •