Advertisement
TO
ADJUST
THROTTLE
CONTROL
CABLE
(See Fig. 33)
The throttle control has been preset at the factory and
adjustment shoutd not be necessary_ Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
•
With engine not running, move throttle control lever
from slow (,,_,) to choke (N) position.
Slowly move
lever from choke (N) to fast (,_) position.
•
Checkthat holes"A" in governor control lever and hole
in governor plate line-upo If holes "A" are not aligned,
loosen clamp screw and move throttle cable until holes
are aligned.
Tighten clamp screw securely,
GOVERNOR
CONTROL
LEVER
GOVERNOR
CONTROL
PLATE
HOLES"A"
CLAMP
THROTTLE
SCREW
CABLE
FIG. 33
TO ADJUST
CARBURETOR
(See Fig. 34)
The carburetor has been preset at the factory and adjust-
ment should not be necessary.
However, minor adjust-
ment may be required to compensate for differences in fuet,
temperature, altitude or load,. If the carburetor does need
adjustment, proceed as follows:
in general, turning idle mixture valve in (clockwise) de-
creases the supply of fuel to the engine giving a leaner fuel/
air mixture,
Turning the idle mixture vafve out (counter-
clockwise) increases the supply of fuel to the engine giving
a richer fuel/air mixture,
IMPORTANT:
DAMAGE TO THE NEEDLE VALVE AND
.THESEAT IN CARBURETOR MAY RESULT IF SCREW IS
TURNED iN TOO TIGHT
PRELIMINARY
SETTING -
.
Air cleaner assembly must be assembled to the carbu-
retor when making carburetor adjustments..
•
Be sure the throttle control cable is adjusted properly
(see above)_
.
With engine off turn idle mixture valve in (clockwise)
closing it finger tight and then turn out (counterclock-
wise) 1 fulf turn.
FINAL SETTING
-
Start engine and atlow to warm for five minutes. Make
final adjustments with engine running and shift/motion
control lever in neutral (N) position.
=
Move throttle control lever to stow (,,=_) position. With
finger, rotate and hold throttle lever against idle speed
screw,r Turn idle speed screw to attain 1750 RPM
•
While still holding throttle
lever against idle speed
screw, turn idle mixture valve in (clockwise) until en-
gine begins to die and then turn out (counterclockwise)
until engine runs rough._ Turn valve to a point midway
between those two positions.
Release throttle lever.
ACCELERATION
TEST -
•
Move throttle control lever from slow (,,_,) to fast (._)
position., if engine hesitates or dies, turn idle mixture
valve out (counterclockwise)
1/8 turn. Repeat test and
continue to adjust, if necessary, until engine acceler-
ates smoothly.
High speed stop is factory adjusted.
Do not adjust -
damage may result.
IMPORTANT:
NEVER TAMPER
WITH THE ENGINE
GOVERNOR, WHICH iS FACTORY SET FOR PROPER
ENGINE SPEED OVERSPEEDfNGTHEENGINEABOVE
THE
FACTORY
HIGH
SPEED
SETTING
CAN BE
DANGEROUS
IF YOU THINK THEENGINE-GOVERNED
HiGH SPEED NEEDS ADJUSTING,
CONTACT
YOUR
NEAREST
AUTHORIZED
SERVICE
CENTER/
DEPARTMENT, WHICFI HAS PROPER EQUIPMENT AND
EXPERIENCE
TO
MAKE
ANY
NECESSARY
ADJUSTMENTS
THROTTLE
IDLE SPEED
LEVER
SCREW
IDLE MIXTURE
VALVE
FIG. 34
27
Advertisement
