Advertisement
Available languages
Available languages
CRAFTSMAN
2 YEAR
FULL
WARRANTY
FOR 2 YEARS from the date of purchase, this product is warranted
against any defects in material or workmanship.
Defective product will receive free repair or
free replacement
if repair is unavailable.
For warranty
coverage
details to obtain repair or replacement,
visit the web site: www.craftsman.com
This warranty
covers
ONLY defects
in material
and workmanship.
Warranty
coverage
does NOT include:
*
Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
*
Product damage resulting from user attempts at product modification
or repair or caused by product accessories.
*
Repairs necessary because of accident or failure to operate or maintain the product according
to all supplied instructions.
*
Preventive maintenance,
or repairs necessary due to improper fuel mixture, contaminated
or stale fuel.
This warranty is void if this product is ever used while providing commercial services or if rented to another person.
This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
Sears Brands Management
Corporation,
Hoffman Estates, IL 60179
APPLiCATiONS
As a trimmer:
* Cutting grass and light weeds
* Edging
* Decorative trimming around trees, fences, etc.
As a brushcutter:
* Cutting weeds and light brush of up to 1/2 inch in diameter
Other optional accessories
may be used with this unit.
Muffler
Spark Plug
Starter
Rope
Shaft Grip
Grip
D-Handle
\,
Shoulder
Strap Clip
ConvertibJe
TM
Coupler
On/Off
Control
Fuel Cap
Throttle
Control
Air Filter
Cover
Shaft Housing
Barrier
Bar
Brush
Blade
Blade Shield /
Shield
Mount
Primer
Bulb
Hassle
Free ®
Cutting
Head
Head Shield
Line Cutting
Blade
iNSTALL AND ADJUST THE D-
HANDLE
1.
Remove the screws and
bottom clamp.
2.
Place the D-handle over the
shaft housing and onto the
bottom clamp (Fig. 1). Move
it a minimum of 6 inches
(15.24 cm) from the end of
the shaft grip.
3.
Start the screws with an
appropriate
tool. Do not
tighten until making the
handle adjustment.
screw 14)..
Barrier Bar
/
Minimum
6 in.
(f 5.24 cm)
Fig. f
Bottom
Clamp
4.
If pre-installed,
loosen the screws just enough to move it.
5.
While holding the unit in the operating position (Fig. 19), move the D-handle
to the location that provides the best grip.
6.
Tighten the clamp screws evenly until handle is secure.
NOTE:
Make sure the barrier bar is on the operating side when the unit is
held in the operating
position.
INSTALL CUTTING ATTACHMENT
SHIELD
J ,A
JWARNING:
To prevent serious personal injury, never operate
the unit without the cutting attachment
shield in place.
Use the following
instructions
if
the cutting attachment
shield on
the unit is not installed.
1.
Place the cutting head shield
onto the guard mount
bracket, making sure to align
the holes on the shield with
the ones in the guard mount
bracket. (Fig. 2)
2.
Take the 2 shield screws and
screw each one into the
shield until finger tight.
\
Cutting
Head Shield
Guard
Mount
Bracket
Fig. 2
Advertisement
