Specific Safety Rules - COMPANION 184.10184-1 Owner's Manual

TOOLUSEANDCARE SERVICE
Useclamps o r otherpractical wayto
secure andsupport
t he workpiece to a
stable platform. Holding the work by hand or
against your body is unstable and may lead
to loss of control.
Do not force the tool. Use the correct tool
for your application. The correct tool will do
the job better and safer at the rate for which it
is designed.
Do not use the tool if the switch does not
turn it ON or OFF. Any tool that cannot be
controlled with the switch is dangerous and
must be repaired.
Disconnect the plug from the power
source before making any adjustments,
changing accessories or storing the tool.
Such preventive safety measures reduce the
risk of starting the tool accidentally.
Store idle tools out of reach of children
and other untrained persons. Tools are
dangerous in the hands of untrained users.
Maintain tools with care. Keep cutting
tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less
likely to bind and are easier to control.
Check for misalignment or binding of
moving parts, breakage of parts and any
other condition that may affect the tool's
operation. If damaged, have the tool
serviced before using. Many accidents are
caused by poorly maintained tools.
Use only accessories that are
recommended by the manufacturer for
your model. Accessories that may be
suitable for one tool may become hazardous
when used on another tool.
Tool service must be performed only by
qualified personnel. Service or
maintenance performed by unqualified
personnel could result in risk of injury.
When servicing a tool, use only identical
replacement parts. Follow instructions in
the Maintenance section of this manual.
Use of unauthorized parts or failure to follow
Maintenance instructions may create a risk of
electric shock or injury.
SPECIFIC SAFETY RULES
IA.A....GJ
For your safety, do not plug in your
charger or install the battery in the tool
until you have read and understood this
Owner's Manual.
WEAR EYE PROTECTION. Use face or
dust mask along with safety goggles if
operation is dusty. Use hearing
protection, particularly during extended
periods of operation.
• DO NOT wear gloves, neckties or loose
clothing.
• DO NOT drill, cut or sand material too
small to be securely held.
ALWAYS keep hands out of the path of
the drill bit and saw blade. Avoid
awkward hand positions where a sudden
slip could cause your hand to move into
the path of the drill bit or saw blade.
SECURE WORKPIECE. Use clamps or
a vice to hold the work when practical. It
is safer than using your hand and it frees
both hands to operate the tool.
• MAKE SURE there are no nails or
foreign objects in the part of the
INSTRUCTIONS _z°zk_e'ce't_'be'r-'_'l-ul_
I_'l-I=l_'.u_" drilled or sanded.
SAVE THESE