Gigabyte GV-RX85T256V-B Manual page 9

4. Locate the PCI Express x 16 slot. If
necessary, remove the metal cover from
this slot; then align your graphics card with
the PCI Express x 16 slot, and press it in
firmly until the card is fully seated.
5. Replace the screw to fasten the card in
place, and replace the computer cover.
6. Plug the display cable into your graphics
card; then turn on the computer and
monitor. To connect a flat panel directly to
your graphics card, use the DVI-I connector.
To connect a VGA monitor to the DVI-I
connector, plug the DVI-I to D-sub adapter
into the DVI-I connector, then plug the
monitor cable into the adapter.
To Flat Panel Display
You are now ready to proceed with the installation of the graphics card drivers. Please
refer to next chapter for detailed instructions.
After installation, please connect the power cable to
your graphics card, or the system will not boot.
Connect a flat panel
Connect a VGA monitor via DVI-I to D-sub adapter
9-Pin for VIVO
- 7 - Hardware Installation