Table of Contents
Advertisement
Quick Links
M SERIES SUBWOOFER
OPERATING INSTRUCTIONS
Thank you for purchasing this Epos M series subwoofer.
The following items are supplied with your subwoofer - should any item be missing please contact
your dealer:
Plinth with 6mm carpet spikes (4) and metal discs (4)
Fixing bolts - long - Type A - (4)
Fixing bolts - short - Type B - (4)
Felt pads (4)
Feet (4)
Power cables (see text in warning section)
WARNING
For safety reasons please read the following instructions carefully before attempting to connect
your Epos M subwoofer to the mains.
The M subwoofer is not designed for permanent external use. Being a powered product it would
be damaged by rain water or other contaminants entering into the amplifier via the vent holes and
the wooden cabinet would be damaged if soaked with water.
As with all electrical products, make sure the correct mains voltage is selected by the two way
selector switch on the rear panel marked AC Voltage Selector. If you are in any doubt, contact your
supplier for advice. As a general rule, the amplifier cannot be damaged by supplying lower
voltages than marked on the switch panel, but excessive voltage will cause the mains fuse to blow
or possibly even damage the internal circuitry (if in doubt, ask your dealer/supplier).
Two power cords are supplied as standard with the M subwoofer. These have the international
IEC connector for plugging into the amplifier panel at one end and either of two styles of plug at
the other end.
USA, Canada and Japan
The USA style plug with two flat blades should be used with the voltage selector switched to 115V
operation and a mains fuse rated at 4 Amp inserted in the pull-out drawer.
Europe
The two round pin Euro plug should be used with the AC Voltage selector switched to 230V.
Rest of World
Your distributor/dealer will ensure you have the correct cable. Please check if in doubt.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for EPOS M Series
Summary of Contents for EPOS M Series
- Page 1 M SERIES SUBWOOFER OPERATING INSTRUCTIONS Thank you for purchasing this Epos M series subwoofer. The following items are supplied with your subwoofer - should any item be missing please contact your dealer: Plinth with 6mm carpet spikes (4) and metal discs (4)
- Page 2 The best way to remove the speaker from the carton is to open the top of the carton, roll it over with the flaps folded out and pull the carton off, leaving the speaker in its protective polyethylene foam.
- Page 3 50mm above the floor. It also has a plinth that fixes to the ends of the feet with long bolts and covers the entire bottom of the speaker. Make sure the plinth is bolted to the cabinet with the Epos badge at the front.
-
Page 4: Subwoofer Controls
You have the choice to use the plinth with, or without, the 6mm carpet spikes that are supplied together with it. The spikes can be adjusted to level the speaker and dig deep into carpet to provide mechanical de-coupling of the device into the floor. Metal discs are also supplied to prevent damage to wooden flooring, if required. - Page 5 Connection should be made from the speaker terminals on your amplification system to the High Level Input Connections. Note: Only connect using line level inputs OR high level inputs.
- Page 6 To protect the M subwoofer's 300W amplifier from excessive current demands, it has been designed to cut the signal to the speaker in the event of an overload. This will temporarily mute the subwoofer and stop it from working until the demand is lower.
- Page 7 Ensure that all cable connections are secure. WARRANTY Your Epos subwoofer has been built to very high standard and should give many years of trouble free use. If within 5 years of the purchase date it proves to be defective for any reason other than accident, misuse, neglect, unauthorized modification, or fair wear and tear, we will, at our discretion, replace the faulty parts without charge for labour or return carriage in the UK.
- Page 8 Weight 12 Avebury Court, Mark Road Hemel Hempstead HP2 7TA England Telephone +44 (0) 1442 260146 Fax: +44 (0) 870 622 0846 Email: info@epos-acoustics.com Internet: www.epos-acoustics.com Class D, high efficiency switching circuit 300 Watts into 4 Ohm load continuous 20Hz to 150Hz with high and low filter settings at...
Need help?
Do you have a question about the M Series and is the answer not in the manual?
Questions and answers