Controller Description & Operation; Display Description (Lcd) - Mitsubishi A0567659 User Manual

4-2 Controller Description & Operation

Display Description (LCD)

The Slide Gate/Auger blending system utilizes a standardized menu format. Each screen
was designed to be user-friendly and provide the operator with the necessary information to
run the blender.
A typical menu is shown in the figure above. This display, which is defaulted to when the
controller is turned on, provides the operator with the following information and options:
Note: Please refer to the Slide Gate/Auger menu structure shown on the next page.
The menu tree shows the structure for a standard Slide Gate/Auger blender.
When the unit is initially installed the Manual Control menu will be used. This screen is
primarily used for trouble shooting the blender. All outputs can be controlled manually and
all digital inputs from the proximity switches can be viewed. Pressing the "Manual Control"
key when in the "Setup" menu accesses this screen. To gain access to the "Setup" menu, a
password will be requested.
Open or Close
Feeder
Open or Close
Weigh Hopper
Start or Stop
Mixer Motor
Open or Close
Mixer Knife
Gate
Gravimetric Batch Blenders w/Mitsubishi Control
• The ability to change Recipe Values
• Accept a newly entered Recipe
• Start or Stop the blender
• Access to the Recipe Book
• Access to the Clean-out Screen
• Access to the Inventory Screen
• Access to the Controller Setup Screen
Warning Message
Low Level
Prox Status
Chapter 4: Operation
Empty Entire
Blender
Test Alarm
Output
Current Hopper
Weight
Go back to
Setup Directory
58