Table of Contents
Advertisement
Watching TV
Antenna / Cable service without a box
Initial setting
1.
Connect coax
Connect a COAX wire from either an antenna or Basic Cable service to the TV's
"ANTENNA/CABLE IN" screw terminal.
TV
2.
Scan the channel
MENU
1. Select Programming source Cable or Antenna in
Auto program
2. Select
(All channels
3. Start scanning.
* If at the end of the scanning no channels are found, then check:
Antenna's position - or Availability of Cable service.
Cable, Satellite or Fiber services with a box are typically connected to the TV's
A/V inputs, preferably HDMI, for best HD picture. In such a case, the channel
scanning is not needed (set
ANTENNA/
CABLE IN
Setup
>
ANT/Cable setup
and select scan mode
Analog only
/
/
ANT IN
Antenna
>
ANT in, Auto program
Ant
Digital
only).
to Not used).
12
in.
Advertisement
Table of Contents
