Brocade Communications Systems PowerEdge M620 Tech Note page 2

SAN TECH NOTE
Enterprise OSc and Enterprise OSn Switches
Ensure that all the following conditions are met:
•
Enterprise OS 9.0 or later with an NPIV license installed.
•
NPIV must be enabled on the ports that connect the Access Gateway to the SAN.
•
Fabric logins on the port and switch that connect the Access Gateway to the SAN set to the
maximum.
•
OpenSysMS (Open Systems Management Server) enabled.
To enable, enter the following in the command-line interface (CLI):
config OpenSysMs setState
C C
ONNECTING TO ISCO
SAN-OS Switches
Ensure that all the following conditions are met:
•
SAN-OS 3.0 or later
•
NPIV must be enabled on the ports that connect the Access Gateway to the SAN.
•
OpenSysMS (Open Systems Management Server) enabled.
© 2008 Brocade Communications Systems, Inc. All Rights Reserved. 02/08 GA-TN-004-01
Brocade, Fabric OS, File Lifecycle Manager, MyView, and StorageX are registered trademarks and the Brocade
B-wing symbol, DCX, and SAN Health are trademarks of Brocade Communications Systems, Inc., in the United
States and/or in other countries. All other brands, products, or service names are or may be trademarks or
service marks of, and are used to identify, products or services of their respective owners.
Notice: This document is for informational purposes only and does not set forth any warranty, expressed or
implied, concerning any equipment, equipment feature, or service offered or to be offered by Brocade.
Brocade reserves the right to make changes to this document at any time, without notice, and assumes no
responsibility for its use. This informational document describes features that may not be currently available.
Contact a Brocade sales office for information on feature and product availability. Export of technical data
contained in this document may require an export license from the United States government.
Preparing to Install the Brocade Access Gateway
F
ABRICS
Page 2 of 2