Table of Contents
Advertisement
CONDENSED OPERATING INSTRUCTIONS
FACTORY PRE-SET "TURN-ON-AND-GO" MARKS
Your CZ-3D is fairly simple to operate, especially when compared
to other target ID machines. Even so, we strongly recommend that
you read this entire manual. You'll be able to tune your CZ-3D to
your specific needs and conditions. A good understanding what
to do and why will lead you to more finds.
If you can't wait any longer, and you're an experienced detector
user, here's some quick instructions to get you going:
1. Set all the controls to the red numbered
2. If you're using headphones, adjust the volume
3
.
4. When you get a good, repeatable signal, pinpoint
5. Once you've pinpointed the target, note the
6. Happy Hunting!
"Turn-On-And-Go" marks:
GROUND = 5
DISC = 4
SENSITIVITY = 3
MODE = ENHANCE
VOLUME = 5
This puts you in a "coins-only" mode and you're
ready to start searching. Keep in mind that the
GROUND setting of 5 is probably not the optimum
setting for the ground you're searching and that's
why the sensitivity level is set low—to reduce false
signals caused by ground mineralization.
controls for a comfortable volume when the coil is
passed over a large shallow object.
Walk slowly, overlap your sweeps and keep the
search coil moving. Remember you are in a "motion"
search mode and the coil must be moving at least
slightly to detect a target.
the target by placing the coil on the ground away
from the target, pushing and holding the pinpoint
button and then bringing the coil back over the
target.
approximate depth reading on the meter, then
identify it by releasing the pinpoint button and
moving the coil side to side in short strokes over
the target. The meter needle will lock onto the
appropriate target classification.
2
Advertisement
Table of Contents
