Table of Contents
Advertisement
Quick Links
®
FALCON
PRECISION UTILITY VOLTAGE
REGULATOR AND CONDITIONER
OWNER'S MANUAL
SVR1K-1T & SVR2K-2T
SVR2K-1T &SVR2K-2T
SVR3K-1 & SVR3K-2T
®
Electric Inc., 5106 Azusa Canyon Rd., Irwindale, California 91706 800-842-6940 Fax: 626-962-7720 Email:
FALCON
®
2005 Falcon
Electric Inc. All rights reserved.
All other brand names and trademarks are the property of their respective owners.
The information and specifications stated in this document are subject to change without notice. 2005-03-21
® Falcon, Falcon Electric and UPS Plus logos are registered trademarks of Falcon Electric , Inc.
OM48021-1 Rev. C
ELECTRIC INC.
SVR SERIES
sales@falconups.com
1
Advertisement
Table of Contents
Summary of Contents for Falcon OM48021-1
- Page 1 All other brand names and trademarks are the property of their respective owners. The information and specifications stated in this document are subject to change without notice. 2005-03-21 ® Falcon, Falcon Electric and UPS Plus logos are registered trademarks of Falcon Electric , Inc. OM48021-1 Rev. C...
-
Page 2: System Block Diagram
COMPACT SIZE, LIGHT WEIGHT • WIDE INPUT VOLTAGE WINDOW • TIGHT OUTPUT VOLTAGE REGULATION (±2%) • INPUT POWER FACTOR CORRECTION • SURGE PROTECTION • HIGH EFFICIENCY • OVER CREST RATIO LED INDICATOR • RS-232 INTERFACE SYSTEM BLOCK DIAGRAM OM48021-1 Rev. C... -
Page 3: Important Safety Instructions
∗ The air should remain free from excessive dust and chemical fumes. Once a location has been selected and the unit is installed, it is ready for operation. This Symbol Denotes Earth Ground This Symbol Denotes On and Off OM48021-1 Rev. C... - Page 4 Turn on the connected equipment and verify the SVR does not go into overload, by using the front panel load indicator. IMPORTANT TO TURN OFF THE SVR, TURN OFF THE INPUT CIRCUIT BREAKER. THE SVR WILL RUN FOR ABOUT 30 SECONDS AND SHUTDOWN. OM48021-1 Rev. C...
- Page 5 When this LED is lit, the SVR inverter is operating and powering the connected load. OVER CREST INDICATOR LED • This LED lights when the connected load is getting close to the peak current rating of the SVR. OM48021-1 Rev. C...
- Page 6 The following describes the different modes of operation for this button: • Pressing the Test button while utility is present will put the SVR through a self test diagnostic. LINE INDICATOR LED • This LED is lit to a steady on state when Utility voltage is present. OM48021-1 Rev. C...
- Page 7 Continuous rapid beeping for about 2 seconds and the SVR shuts down - The SVR performed a DC start, but there is no output frequency set in memory. − − − − − − − − − − = The SVR performed a DC start, but there is no output frequency set in memory. OM48021-1 Rev. C...
-
Page 8: Dip Switch Settings
WARNING – NEVER SERVICE THIS UNIT WHILE THE POWER IS APPLIED; HIGH VOLTAGE EXISTS AND A HAZARD OF ELECTRICAL SHOCK IS PRESENT. WARNING – THIS DEVICE IS INTENDED FOR ADMINISTRATION AND LAB USE. NOT INTENDED FOR LIFE SUPPORT APPLICATIONS. OM48021-1 Rev. C... - Page 9 DO NOT BLOCK OUTPUT INPUT CIRCUIT BREAKER RECEPTACLES ( 6 places without ext e r n a l b a t t e r y option, 4 plac es as shown) POWER INLET OPTIONAL EXTERNAL BATTERY CONNECTOR OM48021-1 Rev. C...
- Page 10 OUTPUT FUSES Configuration (2 places) Shown Contact Factory For Other Configurations OPUTPUT RECEPTACLES ( 6 ) NEMA 5 -15R STANDARD MAIN POWER SWITCH & INPUT CIRCUIT BREA KER INP UT LINE CORD OTHER OUTPUT RECEPTACLE CONFIGURATIONS ARE OM48021-1 Rev. C AVAILABLE.
- Page 11 COOLING FANS DO NOT BLOCK OUTPUT FUSE S (2 places) OPUTPUT RECEPTACLES Shown with (1) L6-20R & (2) 5 - 20R Receptacles MAIN POWER SWITCH & INPUT CIRCUIT BREA KER LINE CORD INLET OTHER OUTPUT RECEPTACLE CONFIGURATIONS AVAILABLE OM48021-1 Rev. C...
- Page 12 10. This product is not recommended, and Falcon Electric inc. will not knowingly sell this product, for use with life support and other designated "critical devices". ANY SUCH USE BY A USER AUTOMATICALLY VOIDS AND DISCLAIMS ANY AND ALL WARRANTIES, INCLUDING...
-
Page 13: Fcc Considerations
The RMA number issued must appear on the outside of the shipping carton. The original shipping container must be used when returning any SVR Series product. Falcon Electric will not assume any responsibility for shipping damage. In the event of shipping damage, you will be charged for repairs due to the damage.