Page 2
INTRODUCTION unit has a sealed lead acid battery that should be kept at full charge. Recharge immediately after each use, and every three months if not used. a full charge may cause the battery life to be reduced greatly. This mit contains a smart circuit which allows it to be left on charge continuously without Jamage.
PORTABLE POWER 3. Optional power charging cord (see 12, Figure 1) SOURCE FEATURES • ES-6000 & ES-6500: Provides plenty of power for starting ESA-21 vehicles. More than enough to start most cars. May also be used in SAFETY SUMMARY DEEP CYCLE applications. •...
Page 4
soap and water. If acid enters eye, Do not submerge in water. immediately flood eye with running Do not operate with flammables cold water for at least tO minutes such as gasoline etc. and get medical attention If the portable power source receives immediately.
Page 5
CHECKING POWER LEVEL c, Allow the portable power source to charge until the CHARGED Check power level of the Portable Power light comes on (you can monitor Source with the test button. Lights will the progress by checking the come on in sequence from empty to the red POWER LEVEL lights - charged light.
Page 6
;ED AS AN EMERGENCY 9. Disconnect the negative (black cable) clamp from vehicle ground IMP STARTER (the engine). power, do not store Disconnect the positive (red cable) below 50 ° when using as a jump clamp from the positive (POS, +) starter.
2. Remove the power extensioncord good connection on the and startthe car. vehicle. Only one side of the clamp carries power-- NOTE:A defective battery may refuse to make sure the side with accept a charge from the portable the cable is connected to power source.
Page 8
!H IMPORTANT in the development and designing of the portable BA'I-rERY REMOVAL power source. Most DISPOSAL battery outlets can dispose of this product at its life's end. Contains sealed, non-spillable lead _estion: What is the ideal in-use IPhl acid battery. Must storage temperature of the...