Hitachi CP-X3011N Network Manual page 11

1.4 Selecting the network connection mode (continued)
A network connection was not established.
The screen is displayed in the case that the
projector is not connected with a LAN cable
to your computer when the wired LAN is
selected.
Be sure that the projector is connected with
a LAN cable to your computer.
Click the [OK], then the screen is back to the previous one to select the network
connection mode.
Windows firewall is enabled (On).
The screen is displayed in the case that
the firewall setting in Windows XP/Vista is
activated, and the "LiveViewer" is blocked
by the firewall.
• To turn it disabled (Off), click the [Yes].
• Not to turn it disabled (Off), click the
[No], but the projector may not be able to
communicate with your computer through
the network.
• If you put a check mark in the [Allow communication with LiveViewer by
adding it to the Exceptions list] box, the "LiveViewer" will never be blocked
by Windows firewall.
Proceed to item 1.5 Selecting the network connection method. (
NOTE • If you click the [Yes], the network access by the "LiveViewer" is
temporally permitted by Windows firewall, until the "LiveViewer" is closed.
• If any application software having the firewall function is installed into you
computer, make the firewall function invalid with following the user's manual.
1. Connection to the network
14)
11