Section 8: Exposure Controls/Personal Protection; Personal Protective Equipment (Ppe); Section 9: Physical And Chemical Properties - 3M Designjet H35000 - Commercial Printer Material Safety Data Sheet

3M MATERIAL SAFETY DATA SHEET 3M Black Inkjet Ink 5495

SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION

8.1 ENGINEERING CONTROLS
Provide local exhaust ventilation at transfer points. Provide appropriate local exhaust when product is heated. Use general dilution
ventilation and/or local exhaust ventilation to control airborne exposures to below Occupational Exposure Limits and/or control mist,
vapor, or spray. If ventilation is not adequate, use respiratory protection equipment.

8.2 PERSONAL PROTECTIVE EQUIPMENT (PPE)

8.2.1 Eye/Face Protection
Avoid eye contact with vapors, mists, or spray.
The following eye protection(s) are recommended: Safety Glasses with side shields, Indirect Vented Goggles.
8.2.2 Skin Protection
Wear appropriate gloves, such as Nomex, when handling this material to prevent thermal burns. Avoid skin contact. Avoid skin
contact with hot material.
Select and use gloves and/or protective clothing to prevent skin contact based on the results of an exposure assessment. Consult with
your glove and/or protective clothing manufacturer for selection of appropriate compatible materials.
Gloves made from the following material(s) are recommended: Nitrile Rubber.
8.2.3 Respiratory Protection
Avoid breathing of vapors, mists or spray.
Select one of the following NIOSH approved respirators based on airborne concentration of contaminants and in accordance with
OSHA regulations: Half facepiece or fullface air-purifying respirator with organic vapor cartridges. Consult the current 3M
Respiratory Selection Guide for additional information or call 1-800-243-4630 for 3M technical assistance.
8.2.4 Prevention of Swallowing
Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with soap and water. Not applicable.
8.3 EXPOSURE GUIDELINES
Ingredient
1,6-HEXANEDIOL DIACRYLATE
BENZOPHENONE
CARBON BLACK
CARBON BLACK
CARBON BLACK
ISOOCTYL ACRYLATE
ISOOCTYL ACRYLATE
TETRAHYDROFURFURYL ACRYLATE
TETRAHYDROFURFURYL ACRYLATE
SOURCE OF EXPOSURE LIMIT DATA:
ACGIH: American Conference of Governmental Industrial Hygienists
CMRG: Chemical Manufacturer Recommended Guideline
OSHA: Occupational Safety and Health Administration
AIHA: American Industrial Hygiene Association Workplace Environmental Exposure Level (WEEL)

SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES

Specific Physical Form:
_________________________________________________________________________________________________
Authority Type
AIHA TWA
AIHA TWA
ACGIH TWA
CMRG TWA
OSHA TWA
3M TWA
AIHA TWA
3M TWA
3M STEL
Liquid
03/12/2007
Limit Additional Information
1 mg/m3 Sensitizer
0.5 mg/m3
3.5 mg/m3 Table A4
0.5 mg/m3
3.5 mg/m3 Table Z-1
5 ppm
5 ppm
0.1 ppm
0.3 ppm
Page 4 of 7