C L A S S 1 L A S E R P R O D U C T A P P A R E I L A L A S E R D E C L A S S E 1 L A S E R K L A S S E 1 L U O K A N 1 L A S E R L A I T E P R O D U I T L A S E R...
FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation.
INTRODUCTION Thank you for the purchase of this perfect and compact dual digital storage drive with the combination of an IDE CD-ReWritable drive and a USB- connected card reader. This drive backs up all writing modes and different CD formats. It supports maximum 52x speed writing ability on CD-R discs, 32x speed on CD-RW discs and 52x speed reading performance.
52X DDS CD-RW Drive INSTALLATION Host Interface Connections Most current motherboards have two IDE ports (primary and secondary) which can connect two IDE cables. Two IDE cables allow you to connect up to four devices, but it is recommended that you separate IDE ports for your hard disk and your CD-ReWritable drive.
Hardware Installation 1. Turn off the power to the computer system. 2. Disconnect the power cord and all cables from the back of your computer, and then remove the cover of the computer. 3. Insert the drive into one of the vacant 5.25" drive bays and secure it with screws to your PC.
Page 9
6. Connect the USB cable at the back of the drive to the USB header on the computer’s motherboard. The red wire of the cable needs to be plugged into Pin 1 on the board. This drive supports USB 2.0 and if you connect to USB 1.1 connector, only transfer rate of USB 1.1 will be available.
Software Installation The bundled mastering software gives you the complete solution for making audio/data CDs. With the user-friendly interface, it guides you through the creation and backup of files/photos/video/music from your computer to a recordable compact disc. Combining of the card reader capabilities, no matter you are a novice or an experienced user;...
CONNECTION & OPERATION Front Panel 1. A-Type USB Extension Port This USB port is Plug-and-Play Ready. Just plug your USB device and the computer will detect automatically. 2. Close/Eject Button This button opens and closes the disc tray. If the tray is closed, pressing the button will eject it.
Page 12
5. Emergency Eject Hole When the Close/Eject button doesn’t work properly and the disc tray can’t be opened, you can insert a paper clip or a small rod into this hole for manual ejection. Please make sure to power off the system before you do that.
Rear View 1. Digital Audio Output Connector If your sound card has a digital audio IEC958 format connector, you can connect it to this digital audio output connector with a 2-pin audio cable. 2. Analog Audio Output Connector This connector allows you to connect the drive to your sound card with a 4-pin audio cable.
Page 14
52X DDS CD-RW Drive 6. USB Cable Connect the USB cable to the USB connector on the motherboard. The red wire of the cable needs to be plugged into Pin 1 on the board.
TECHNICAL DATA Interface Form factor Writing speed Writing modes Digital Media CD format support Transfer rate CD-RW Drive Card Reader Data buffer CD-RW Drive: EIDE Card Reader: USB 2.0 5.25" Half Height CD-R: 8X/16X/24X/32X/40X/48X/52X CD-RW: 4X/10X/12X/16X/20X/24X/32X TAO (Track at once), DAO (Disc At Once), SAO (Session at once), Multi-session, Packet Writing CompactFlash, MicroDrive, Memory...
Need help?
Do you have a question about the 52X DDS and is the answer not in the manual?
Questions and answers