Tips For Successful Sublimation - Sawgrass Technologies Stylus D88 Getting Started Manual

Sawgrass Technologies, Inc.

Tips for Successful Sublimation

POLYESTER FABRIC
Maintain appropriate heat press times.
Shortened pressing times will result in good surface color but the
sublimation dyes will not completely penetrate the polyester fibers. This
leaves the dyes more susceptible to wash out.
Longer pressing times will cause the dye molecules to penetrate deeper
into the fiber, creating a washed out look. For guidelines on transfer
times, see the section entitled Heat Transfer Instructions.
Maintain appropriate heat press temperatures & pressure
The correct temperature setting is vital for achieving desired results.
Higher temperatures can damage the polyester fibers to the point that
they cannot properly "hold" the dyes. For guidelines on transfer
temperatures, see the section entitled Heat Transfer Instructions.
Too much pressure on the heat press may cause the dyes to penetrate
too deeply into the fabric causing a washed out look. For guidelines on
transfer pressure see the section entitled Heat Transfer Instructions.
METAL
To obtain the best results when printing onto metal, place the transfer
between the metal and an absorbent cloth or fresh, non-textured paper
towel. This will absorb any dyes that pass back through the paper and any
moisture released during the transfer process. If you have problems with
inconsistently filled areas, this may alleviate the problem.
CERAMIC TILES & MUGS
When transferring onto ceramic tiles and mugs, immediately peel the paper
off of the ceramic after removing it from the heat press. Once the paper has
been removed, cool the ceramic by submerging it in cool water, or run water
over it from a faucet. If paper residue remains on the surface of the ceramic,
clean with citrus cleaner. If you experience a significant paper-sticking
problem, call your SubliJet reseller for assistance.
®
SubliJet IQ Getting Started Guide for the EPSON Stylus D88
51