Advertisement
2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATAII Connectors
(SATAII_1: see p.2, No. 20)
(SATAII_2: see p.2, No. 19)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.2 No. 8)
(9-pin USB4_5)
(see p.2 No. 9)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2 No. 18)
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
These Serial ATAII (SATAII)
SATAII_2
connectors support SATAII
or SATA hard disk for internal
storage devices. The current
SATAII_1
SATAII interface allows up to
3.0 Gb/s data transfer rate.
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on the motherboard.
Besides four default USB 2.0
ports on the I/O panel, there are
two USB 2.0 headers on this
motherboard. Each USB 2.0
header can support two USB
2.0 ports.
This is an interface for front
panel audio cable that allows
convenient connection and
control of audio devices.
ASRock PV530 Motherboard
1 3
1 3
1 3
1 3
1 3
Advertisement
