Environmental Concerns - Electrolux ECF31461W User Manual

Hide thumbs Also See for ECF31461W:
Table of Contents

Advertisement

12 electrolux
ture corresponds to the climate class indi-
cated on the rating plate of the appliance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Electrical Connection
Caution! Any electrical work required
to install this appliance should be
carried out by a qualified electrician or
competent person.
Warning! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
1
5
Important! The wires in the mains lead are
coloured in accordance with the following
code:
1
Green and Yellow:

ENVIRONMENTAL CONCERNS

The symbol
on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
2
3
4
Earth
3
Brown:
5
Blue:
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter "E" or by the earth sym-
bol
or coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter
"N" or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
"L" or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp
is secure over the outer sheath.
5. Make sure the electricity supply voltage
is the same as that indicated on the ap-
pliance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp
2
plug fitted
. In the event of having to
change the fuse in the plug supplied, a 13
amp ASTA approved (BS 1362) fuse must
be used.
Warning! A cut off plug inserted into a
13 amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
Ventilation requirements
1. Put the freezer in horizontal position on
a firm surface. The cabinet must be on
all four feet.
2. Make sure that the clearance between
the appliance and rear wall is 5 cm.
3. Make sure that the clearance between
the appliance and the sides is 5 cm.
The airflow behind the appliance must be
sufficient.
it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipment. By ensuring this
Live
Neutral
4

Advertisement

Table of Contents
loading

Table of Contents