Control Panel - Electrolux REX CI120FA User Manual

4 electrolux
Service
• Any electrical work required to do the serv-
icing of the appliance should be carried
out by a qualified electrician or compe-
tent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,

CONTROL PANEL

1 Pilot light
2 Temperature regulator
3 Fast Freeze light
4 Fast Freeze switch
5 Alarm light
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise
to a medium setting.
The pilot light will light up.
Important! If the temperature inside the
appliance is too high the Alarm light will
blink. Active the Fast Freeze function.
Switching off
To turn off the appliance, turn the Tempera-
ture regulator to the "O" position.
The pilot light will switch off.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as fol-
lows:
• turn the Temperature regulator toward
lower settings to obtain the minimum cold-
ness.
1 2
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban re-
fuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
3 4 5
• turn the Temperature regulator toward
higher settings to obtain the maximum
coldness.
A medium setting is generally the most
suitable.
However, the exact setting should be chos-
en keeping in mind that the temperature in-
side the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Fast Freeze function
You can activate the Fast Freeze function
by pressing the Fast Freeze switch.
The Fast Freeze light will light up.
This function stops automatically after 52
hours.
It is possible to deactivate the function at
any time by pressing the Fast Freeze switch.
The Fast Freeze light will switch off.
Excessive temperature alarm
An increase in the temperature in a compart-
ment (for example due to an power failure)
is indicated by flashing of the Alarm light.
When normal conditions are restored the
Alarm light will switch off automatically.
are recyclable.