Preparation For Use; Unpacking And Setup; Speaker Connection - Emerson Research ES1 Owner's Manual

UNPACKING AND SET-UP
• Carefully remove the unit from the carton and remove all packing material from the unit.
• Remove any labels or stickers which may be on the front or top of the set, but do not remove any
labels from the back or bottom.
• We suggest that you retain the original carton and packing materials in case it ever becomes
necessary to return your unit for service. This is the only sure way to protect the unit from damage
in transit.
• If you do dispose of the carton and packing materials, please do so properly.

SPEAKER CONNECTION

The color-coded speaker cables must be connected to the
terminals on the back of the speaker cabinet and the back
of the main unit. Make both connections before you plug in
the unit.
To insert wires into the terminals on the back of the main
unit:
1. Locate the bare ends of the wires and separate the
black wire from the red.
2. Lightly flip open the tab of the red (+) terminal, insert
the bare end of the red wire and snap the tab closed.
3. Repeat for the black (-) terminal and wire.
To insert wires into the terminals on the back of the
speaker:
1. Locate the bare ends of the wires and separate the
black wire from the red.
2. Press and hold down on the tab to open the red
terminal, then insert the red (+) wire.
3. Release to lock wire in terminal.
4. Use the same procedure to insert black (-) wire into
black terminal.
WARNING: Be sure to follow these instructions carefully. The system can be damaged if
speakers are improperly connected.

PREPARATION FOR USE

3